Husqvarna 335RJ, 335RJX-Series Assembly, Fitting the J-handle, Assembling the cutting equipment

Page 11

ASSEMBLY

Fitting the J-handle

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•Fit the nut, knob and screw. Do not overtighten.

•Attach the J-handle to the loop handle using the three screws, as shown.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

WARNING! Only grass blades/grass cutters

!or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J-handle.

Assembling the cutting equipment

WARNING!

!When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the guard extension

CAUTION! The guard extension shall always be fitted when using the trimmer head/plastic blades and combination guard. The guard extension shall always be removed when using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination guard. Then click the guard extension into position on the guard with the four quick-fasteners.

The guard extension is removed easily using the spark plug spanner, see illustration.

English – 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 333RJ 335RJX-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lock Machine′s safety equipmentStop switch Muffler Cutting attachment guardVibration damping system Cutting equipment Cutting equipmentLocking nut Trimmer head Sharpening grass cutters and grass bladesFitting the guard extension AssemblyFitting the J-handle Assembling the cutting equipmentHook the blade guard/combination guard a onto Fuel Fuel safetyFuel Handling Mixing FuellingStarting Starting and StoppingCheck before starting Starting and stoppingStopping Basic working techniques Basic safety rulesWorking Techniques General working instructionsGrass trimming with a trimmer head Grass clearing using a grass bladeCarburettor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburettor MufflerAir filter Cleaning the air filterCooling system Bevel gearSpark plug Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApplies to Europe only EC-declaration of conformityPage S35 095-.106 T35 ´z+R3,¶6/¨ Page 1150191-26 ´z+R3,¶6/¨ ´z+R3,¶6/¨
Top Page Image Contents