Husqvarna 125LDx Fuelling, Mixing, Add the remaining amount of petrol, Operating problems, Min m

Page 11

FUEL HANDLING

Mixing

SAlways mix the petrol and oil in a clean container intended for fuel.

SAlways start by flling half the amount of the petrol to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture.

Add the remaining amount of petrol.

SMix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank.

SDo not mix more than one month’s sup-

ply of fuel at a time.

SIf the machine is not used for some time, the fuel tank should be emptied and cleaned.

WARNING: The muffler gets very hot during and after use. This also applies during idling. Be aware of the fire hazard, especially when working near flammable sub- stances and/or vapors.

Fuelling

WARNING: Taking the following precautions, will lessen the risk of fire:

Do not smoke or place hot objects near fuel.

Always shut off the engine before refueling.

Always stop the engine and let it cool for a few minutes before refu- elling.

When refueling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refueling.

Always move the machine away from the refueling area before starting.

SClean the area around the fuel cap. Contamination in the tank can cause

operating problems.

SEnsure that the fuel is well mixed by shak- ing the container before filling the tank.

Min. 3 m

11

Image 11
Contents LDx Always wear Symbol ExplanationSymbols Contents Upper shaft Air filter cover Lower shaft What is WHAT?Know your trimmer Primer bulbPersonal protective equipment General Safety PrecautionsWear anti--slip and stable boots Throttle lock Machine’s safety equipmentStop switch Muffler Cutting attachment guardMake sure that the cutter on the trimmer Cutting equipmentTrimmer head Fitting the trimmer guard and trimmer head AssemblyFitting the loop handle Assembling and dismantling the two--piece shaftFuel Fuel safetyFuel Handling Add the remaining amount of petrol Operating problemsFuelling MixingCold engine Starting and StoppingCheck before starting Starting and stoppingThis can damage the machine Warm engineStopping Basic working techniques Basic safety rulesWorking Techniques General working instructionsStop the machine immediately if anyone approaches ClearingCutting SweepingMuffler MaintenanceUnit/Maintenance Safety CarburetorTwo--piece shaft Cleaning the air filterLoss of engine power Spark plugBevel gear Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical Data952 715 Declaration of ConformityModel 125LDx M10 LH arbor shaft thread Attachments Part. noTrimmer Head Line Loading Instructions Plastic Blades Tri Cut