Ryobi 705r manual Installing the Cutting Attachment Shield, Decal, Model 725r

ASSEMBLY INSTRUCTIONS

3.Slide the J-handle out until the arrow/white line on the decal touches the clamp assembly (Fig. 5).

Decal

Fig. 5

4.While holding the unit in the operating position (Fig. 6), position the J-handle to the location that provides you the best grip.

Model 725r

Fig. 6

5.Tighten the clamp screws evenly until the J-handle is secure.

INSTALLING THE CUTTING

ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.

1.Place the cutting attachment shield onto the shaft housing above the clamp assembly, so that the shield is in front of the cutting attachment (Fig. 7).

Shaft Housing

Fig. 7

2.Push the cutting attachment shield down to the top of the cutting attachment assembly. Rotate the cutting attachment shield so that it points to the engine, and the holes in the cutting attachment shield line up with the holes in the top of the cutting attachment assembly (Fig. 8).

3.Install the four (4) screws with a small Phillips screwdriver (Fig. 8).

Screw

Cutting Attachment Shield

Cutting Attachment

Fig. 8

10