Ryobi 766r Installing the Cutting Attachment Shield, Shield Mount Cutting Attachment, Screws

Page 10

ASSEMBLY INSTRUCTIONS

INSTALLING THE CUTTING

ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.

1.Slide the cutting attachment shield into the shield mount on the cutting attachment. Align the screw holes in the shield with the holes in the cutting attachment (Fig. 4).

	Shaft Housing	Cutting Attachment
	Shaft Housing	Shield
		Shield

Shield Mount

Cutting Attachment

Fig. 4

2.Place a hex lock nut into one of the three recessed holes on the top of the cutting attachment shield (Fig 5).

Cutting Attachment

Shield

Recessed Holes Hex Lock Nut

3.Install a screw into the hole from the bottom of the cutting attachment shield and screw it into the nut installed in step #2 (Fig 6). Do not tighten.

Screws

Fig. 6

4.Repeat steps 2 and 3 until all three screws have been started, then tighten screws securely with a Phillips head screwdriver.

Fig. 5

10

Image 10

Contents OPERATOR’S Manual Table of Contents IntroductionCalifornia Emission Regulations Spark ArrestorRules for Safe Operation Safety Warnings for GAS TrimmersSymbol Meaning Before OperatingWhile Operating Other Safety Warnings Choke Control HOT Surface WarningSharp Blade Do not USE Blades Indicates OIL Full Choke position Partial Choke positionKnow Your Unit Application Installing and Adjusting the D-HANDLE Assembly InstructionsGrip Wing Nut Bolt Washer Shield Mount Cutting Attachment Installing the Cutting Attachment ShieldShield ScrewsOIL and Fuel Information Using Blended FuelsUsing Fuel Additives OIL and Fuel Mixing InstructionsStarting Instructions STARTING/STOPPING InstructionsStopping Instructions Holding the Trimmer Adjusting Trimming Line Length Operating InstructionsFrequency Maintenance Required Refer to Maintenance and Repair InstructionsMaintenance Schedule Tips for Best Trimming ResultsOuter Spool Inner Reel Shaft Spring Line InstallationWinding the Existing Inner Reel Bump KnobHolding Slots Removing the Air Filter/Muffler Cover Installing a Prewound ReelAIR Filter Maintenance Choke Lever Partial Choke Position B ScrewsReinstalling the Air Filter/Muffler Cover Cleaning the Air FilterAir Filter Adjust Idle Speed Screw Carburetor AdjustmentClean Air Filter Check Fuel Mixture110-120 in.lb .3-13.5 Nm ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug 020Storage Cleaning and StorageCleaning Long Term StorageTroubleshooting Problem Cause ActionEngine SpecificationsDrive Shaft & String Head Page Owners Warranty Responsibilities Ryobi Canada INC Limited TWO-YEAR WarrantyRyobi Outdoor Products Save These Instructions for Future Reference