Ryobi 766r manual Cleaning the Air Filter, Reinstalling the Air Filter/Muffler Cover

Page 18

MAINTENANCE AND REPAIR INSTRUCTIONS

Cleaning the Air Filter

WARNING: To avoid serious personal injury, always turn your trimmer off and allow it to cool before you clean or do any maintenance on it.

Clean and re-oil the air filter every 10 hours of operation. It is an important item to maintain. Not maintaining the air filter will VOID the warranty.

1.Remove air filter/muffler cover. See Removing the Air filter/Muffler Cover, Pg. 17.

2.Remove the air filter from behind the air filter/muffler cover (Fig. 22).

Air Filter

Fig. 22

3.Wash the filter in detergent and water

(Fig. 23). Rinse the filter thoroughly. Squeeze out excess water. Allow it to dry completely.

Fig. 23

4.Apply enough clean SAE 30 oil to lightly coat the filter (Fig. 24).

Fig. 24

5.Squeeze the filter to spread and remove excess oil (Fig. 25).

Fig. 25

6.Replace the air filter in the

air filter/muffler cover (Fig. 22).

NOTE: Operating the unit without the air filter and air filter/muffler cover assembly, will VOID the warranty.

Reinstalling the Air Filter/Muffler Cover

1.Place the air filter/muffler cover over the back of the carburetor and muffler.

NOTE: The choke lever must be in the PARTIAL choke position (B) (Fig. 21, Pg. 17) to install the air filter/muffler cover.

2.Insert the four (4) screws into the holes in the air filter/muffler cover and tighten. Do not over tighten.

18

Image 18
Contents OPERATOR’S Manual Table of Contents IntroductionCalifornia Emission Regulations Spark ArrestorRules for Safe Operation Safety Warnings for GAS TrimmersSymbol Meaning Before OperatingWhile Operating Other Safety Warnings Choke Control HOT Surface WarningSharp Blade Do not USE Blades Indicates OIL Full Choke position Partial Choke positionKnow Your Unit Application Assembly Instructions Installing and Adjusting the D-HANDLEGrip Wing Nut Bolt Washer Shield Mount Cutting Attachment Installing the Cutting Attachment ShieldShield ScrewsOIL and Fuel Information Using Blended FuelsUsing Fuel Additives OIL and Fuel Mixing InstructionsSTARTING/STOPPING Instructions Starting InstructionsStopping Instructions Holding the Trimmer Adjusting Trimming Line Length Operating InstructionsFrequency Maintenance Required Refer to Maintenance and Repair InstructionsMaintenance Schedule Tips for Best Trimming ResultsOuter Spool Inner Reel Shaft Spring Line InstallationWinding the Existing Inner Reel Bump KnobHolding Slots Removing the Air Filter/Muffler Cover Installing a Prewound ReelAIR Filter Maintenance Choke Lever Partial Choke Position B ScrewsCleaning the Air Filter Reinstalling the Air Filter/Muffler CoverAir Filter Adjust Idle Speed Screw Carburetor AdjustmentClean Air Filter Check Fuel Mixture110-120 in.lb .3-13.5 Nm ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug 020Storage Cleaning and StorageCleaning Long Term StorageTroubleshooting Problem Cause ActionSpecifications EngineDrive Shaft & String Head Page Owners Warranty Responsibilities Ryobi Canada INC Limited TWO-YEAR WarrantyRyobi Outdoor Products Save These Instructions for Future Reference