Ryobi 766r manual Assembly Instructions, Installing and Adjusting the D-HANDLE

ASSEMBLY INSTRUCTIONS

INSTALLING AND ADJUSTING THE D-HANDLE

1.Push the D-handle down onto the shaft housing so that the handle slants towards the powerhead (Fig. 1). The squared bolt hole in the handle is to the right.

5.Tighten the wing nut (Fig. 3).

Grip

	Wing
	Nut	Fig. 3
Bolt	Washer

Fig. 1

2.Insert the shoulder bolt into the squared hole in the handle. Place the washer on the bolt, and screw the wing nut onto the bolt.

3.Rotate the D-handle to place the grip above the top of the shaft housing.

4.While holding the unit in the operating position (Fig. 2), position the D-handle to the location that provides you the best grip.

Fig. 2

9