Gear Housing Assembly, Drive Shaft Assembly

Shaft Hedge Clipper Attachment 11 Operator's Manual

WARNING

Blades are very sharp. Wear gloves to protect hands, otherwise serious personal injury may result.

1.Brush loose debris from blade and coat both sides of blade with the 50-50 cleaning mixture.

2.Allow cleaning mixture to soften the remaining gummy residue then wipe it from the blade.

3.Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated.

4.Wipe excess oil from the blade before putting the unit back in ser- vice.

Tools required: Grease gun, clean rag

Parts required: POWER BLENDXTM 14 oz. cartridge P/N 91015 or Lithium Based Grease

1.Clean dirt from grease fitting (A).

2.Carefully pump grease in fitting. DO NOT force grease.

Too much pressure will force grease past seals and cause damage. Apply 1-2 pumps of grease every 15-25 hours of operation.

NOTE

Hedge Clipper drive shaft should be greased every 25 hours of operation.

Tools required: 4 mm hex wrench, clean rag, small brush

Parts required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Based Grease.