12 
WARNING
Blades are very sharp. Wear gloves to protect hands, otherwise serious personal injury may result.
1.Remove gear housing locating screw (A) and loosen clamping screw (B). Remove the gear housing assembly from the drive shaft housing.
2.Pull the drive shaft (C) from the housing, wipe clean and
3.Slide the flexible shaft back in the drive housing being careful not to get dirt on the flex shaft.
4.Slide Gear Housing Assembly onto Drive Shaft. Be certain the Flex Drive Shaft engages the hole in Driver Gear.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
5.Align locating hole in gear housing with locator hole in drive shaft.
6.Install locating screw (A). Tighten clamping screw (B).
C
B
A
C
A
B
D
sharpening blades
Level 2.
Tools required: Flat file, Screwdriver
Parts required: None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.