Shaft Hedge Clipper Attachment 13 Operator's Manual
1.Move stop switch to stop position.
2.Disconnect spark plug wire.
3.Slide blades to allow file clearance using slots (B) on bottom of blade. Do not pry against cutting edges.
4.File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used DO NOT allow blade to over heat.
5.Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized ECHO Servicing Dealer, otherwise premature wear or internal damage may occur.
B |
45º |
6mm (.25 in.) Radius |
blade adjustment
Level 2.
Tools Required: 8 mm Socket & Extension, 4mm Hex Wrench w/ extension
1.Move stop switch to STOP position.
2.Disconnect spark plug wire.
WARNING
Hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Use long hex wrenches and sockets with extensions when tightening blade screws and blade locknuts to keep hands at a safe distance from sharp blades.
3.Tighten blade screws (A) securely.
4.Hold blade screws (A) to prevent turning, and tighten locknuts (B).
A
B