MAINTENANCE | |
|
|
Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations. Carburetor adjustments, other than idle speed, must be performed by an authorized ECHO dealer.
1.Check idle speed and reset if necessary. If a tachometer is available, idle speed screw (A) should be set to the specifications found on “Specifications” page of this manual. Turn idle screw (A) clockwise to increase idle speed; counter clockwise to decrease idle speed.
A
When carburetor adjustment is completed, the cutting attachment should not move at idle, otherwise serious personal injury may result.
Lubrication
Level 1.
Parts | POWER BLENDXTM 8 oz. or Lithium Base |
Required: | Grease. |
Drive Shaft Upper
1.Loosen clamping knob (A).
2.Pull locator pin (B) and rotate 1/4 turn counter clockwise to lockout position.
3.Remove attachment.
C
A
D
B
4.Remove coupler (E) from upper drive shaft assembly by loosening clamping screw (C) and removing set screw (D).
E
A
D
B
X7502312904 | 23 |
© 1/2014 ECHO Inc.