Echo PAS-280 specifications Maintenance

Page 24

MAINTENANCE	PAS-280

5.Remove upper flex cable (F), wipe clean, and apply a thin coating of 1/2 oz. (15ml) of grease.

6.Install cable. Make sure that the flex cable fully engages into the clutch square drive socket.

7.Slide coupler on upper drive shaft until fully seated, and align set screw hole in coupling with hole in upper drive shaft.

8.Install and tighten set screw (D), and tighten clamping screw

(C).

F

24	X7502312904

© 1/2014 ECHO Inc.

Image 24

Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationSafety Additional or Replacement ManualsManual Safety Symbols and Important Information International Symbols On / OFFPersonal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment Emission Control Exhaust & Evaporative EPA 2010 and Later and/or C.A.R.B. TierProduct Emission Durability Emission Compliance Period Description Description Contents Assembly Power Head Shaft/Lower Shaft AssemblySupport Handle Installation Operation FuelFuel Requirements Handling Fuel After useStarting Cold Engine Purge BulbStarting Warm Engine Stopping EngineMaintenance Maintenance IntervalsSkill Levels Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenCarburetor Adjustment Exhaust Port CleaningEngine Break-In High Altitude OperationLubrication Drive Shaft UpperMaintenance Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelSpecifications Echo Approved Optional AttachmentsWarranty Statements OWNER’S ResponsibilityWarranty Statements PAS-280 ECHO, Incorporated