Echo SRM-225I manual Lubrication, Gear Housing, Drive Shaft

24

lubrication

Level 1.

Tools Required: 13mm Open End Wrench, T27 Torx L-Wrench, Clean Rag, Grease Gun

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease.

Gear Housing

1.Clean all loose debris from gear box.

2.Remove plug (A) and check level of grease.

3.Add grease if necessary. DO NOT over-fill.

Drive Shaft

1.Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive shaft housing.

2.Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.

4.Install the gear housing and shield assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

A A

C

B

B

D