Echo SRM-225I manual Grass Trimmer/Brush Cutter 17 Operators Manual, Starting warm engine

Page 17

Grass Trimmer/Brush Cutter 17 Operator's Manual

starting warm engine

The starting procedure is the same as Cold Start except DO NOT close the choke, and do not hold throttle trigger fully depressed.

WARNING

The attachment should not move at idle, otherwise serious per- sonal injury may result.

NOTE

If attachment moves, readjust carburetor according to “Carburetor Adjustment” instructions in this manual or see your ECHO Dealer.

1.Stop Switch

Move stop switch button (A) forward away from the STOP posi- tion.

2.Purge Bulb

Pump purge bulb (C) until fuel is visible in the "Clear" fuel return line.

NOTE

Energy is stored in the starter spring each time the handle/rope is pulled. Generally two to six pulls, using light pulling forces, will store enough energy to engage the starter and spin the engine. Do not pull the rope out to end stop.

3.Recoil Starter

Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Gently pull the recoil starter handle (D) until engine fires.

NOTE

If engine does not start after 5 pulls, use Cold Start Procedure.

A

C

D

stopping engine

1.Release Throttle.

Allow engine to return to idle before shutting off engine.

2.Stop Switch

Move stop switch button (A) backward to STOP position.

WARNING

If engine does not stop when stop switch is moved to STOP posi- tion, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using trimmer again.

A

Image 17
Contents Grass Trimmer/Brush Cutter Table of Contents Safety manualIntroduction Operators manualInternational symbols Safety Manual safety symbols and important informationPersonal condition and safety equipment Grass Trimmer /Brush Cutter Operator s ManualEye Protection Physical ConditionHand Protection Hearing ProtectionRead the Manuals Repetitive Stress InjuriesClear the Work Area Keep a Firm GripEPA 2010 and Later and/or C.A.R.B. Tier EquipmentEmission Control exhaust & evaporative Hot Decal near muffler Shaft Decal Grass Trimmer /Brush Cutter Operator s Manual DescriptionPage Assembly Plastic shield installation ContentsNylon line replacement Nylon line head installationTo advance trimmer line Remove nylon line headOperation Front handle installationGrass Trimmer/Brush Cutter Operators Manual Preparing the Trimmer/Brush Cutter for Blade Use Operation with bladesGrass/Weed Blades Require Brush/Clearing Blades RequireChoosing the Correct Blade Fuel Requirements FuelHandling Fuel Purge Bulb Starting cold engineStopping engine Grass Trimmer/Brush Cutter 17 Operators ManualStarting warm engine Skill levels MaintenanceMaintenance intervals Fuel filter Air filterCooling system Spark plugSpark Arrestor Screen Grass Trimmer/Brush Cutter 21 Operators ManualExhaust system Exhaust Port Cleaning High Altitude Operation Carburetor adjustmentEngine Break-In Drive Shaft Gear HousingLubrication Nylon line replacement Page Sharpening metal blades Engine Problem Troubleshooting Chart TroubleshootingStorage Long Term Storage over 30 daysModel SRM-225 SpecificationsExceptions Warranty Statements99922201032 12/03/09 01/2010 Page Grass Trimmer/Brush Cutter 35 Operators Manual Warranty registration Additional or replacement manuals ServiceServicing Information parts/serial number Echo consumer product support