Craftsman 358.791051 manual Findingfueloroilresidueonmuffleris, Assembly, Trimmer Attach Ment

Findingfueloroilresidueonmuffleris				attachments are designed to be used in
normalduetocarburetoradjustmentsthe primary hole unless otherwise
andtestingdonebythemanufacturerstated.					in the applicable attachment op-
ASSEMBLY				erator's manual. Using		the wrong hole
				could lead to serious injury or damage
_WARNING:		Always	stop unit	to the	unit.
and disconnect spark plug before per-
forming	any assembly procedures.				Secondary	Hole
WARNING"		If received as-
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners	are	secure.
INSTALLING		TRIMMER	ATTACH-
MENT				Locking/Release

CAUTION: When installing trimmer attachment, place the unit on a flat surface for stability.

1.Loosen the coupler by turning the knob counterclockwise.

Coupler

Shipping protector

Knob

TIGHTEN

2.Remove shipping protector from coupler.

3.Remove the shaft cap from the trimmer attachment (if present).

4.Position locking/release button of attachment into guide recess of coupler.

5.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole.

6.Before using the unit, tighten the

knob securely by turning clock- wise.

Button in Primary Hole

For optional attachments, see the AS- SEMBLY section of the applicable at- tachment operator's manual.

ATTACHING SHIELD

,_WARNING: The shield must be properly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on under- side of shield) is sharp and can cut you.

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OP-

ERATION section.

1.Remove wing nut from shield.

2.Insert bracket into slot as shown.

3.Pivot shield until bolt passes through hole in bracket.

4.Securely tighten wing nut onto bolt.

Wing Nut

Bracket_/

Slot

Coupler Primary Hole

Guide Recess

Locking/

Upper Release Attachment

Shaft

Button

_WARNING: Make sure the lock-

ing/release button is locked in the pri- mary hole and the knob is securely tightened before operating the unit. All

SI

Gearbox

Shield

ADJUSTING THE HANDLE

,_WARNING: When adjusting the handle, be sure it remains above the

safety label and below the mark or ar- row on the shaft.

1.Loosen wing nut on handle.

2.Rotate the handle on the shaft to an upright position; retighten wing nut.

lO