Craftsman 240.74817, 700995, 240.74291 manual Pullthepowerhandleandtool, AttachingtheBattery

Figure4

2.Pullthepowerhandleandtool

attachmentapartThepowerhandle. andtoolattachmentshouldseparate easilyIftheydonot,checktobe. surethatthelockringisinthefully unlockedposition.

AttachingtheBattery

1.Aligntheribonthebatterypackwith thecorrespondingslotintheendofthe powerhandle(seefigure5).

I

Figure 5

2. Insert the battery fully into the

handle making sure that the spring- loaded buttons on each side of the

battery pack snap into place in the handle.

Removing the Battery

1.Depress the spring-loaded buttons on both sides of the battery simultaneously. (see figure 6)

0

Figure 6

2.Pull the battery pack straight out from the handle.

To turn the tool on:

1.Grip the control grip firmly with one hand and grip the auxiliary handle on

the tool attachment (if provided) with the other hand.

2.Push the switch that your thumb rests on straight forward; this is the safety release. (see figure 7)

Figure 7

3.While holding the switch under your thumb in the forward position, use your fingers to pull upward on the control trigger. (see figure 8) This will energize the tool and allow you to do your work. It is NOT necessary to keep pressure on the thumb switch after the tool has started.

Please note that the tool will not start if the lock ring is not in the fully locked position.