Avoid Accidental Start – Do not carry plugged in appliance with finger on trigger. Be sure the switch trigger is not
Do not use tool if switch trigger does not turn it on or off. Any tool that cannot be controlled with the switch trigger is dangerous and must be repaired.
Disconnect appliance from power source before storing, servicing, changing accessories such as cutting line. Such preventive safety measures reduce the risk of starting the tool accidentally.
Use only identical manufacturer’s replacement parts and accessories. Use of any other parts may create a hazard or cause product damage. Maintain appliance with care - Replace string head if cracked, chipped, or damaged in any way.
Be sure the string head is properly installed and securely fastened. Failure to do so can causeserious injury.
Make sure all guards, straps, deflectors and handles are properly and securely attached. Use only the manufacturer’s replacement string in the cutting head. Do not use any other cutting attachment, for example, metal wire, rope, or the like. To install any other brand of cutting head to this string trimmer can result in serious personal injury.
Never operate unit without the grass deflector in place and in good condition.
Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged must be properly repaired or replaced by an authorized service center to avoid riskof personal injury.
Maintain a firm grip on both handles while trimming. Keep string head below waist level. Nevercut with the string head located over 30in, or more above the ground.
Store idle appliances - When not in use, string trimmer should be stored indoors in a dry, locked place out of the reach of children. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. A wire gauge size (A.W.G.) of at least 16 is recommended for an extension cord 50 feet or less in length. A cord exceeding 100 feet is not recommended. If in doubt, use the next heavier gauge. The smaller the gaugenumber, the heavier the cord. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.
Never use blades or flailing devices. Unit is designed for line trimmer use only. Use of any other accessories or attachments will increase the risk of injury. Inspect area to be cut. Remove objects (rocks, broken glass, nails, wire, string, etc.) which can be thrown or become entangled in cutting head.
Keep the air vents clean and free of debris to avoid overheating the motor. Clean after each use.
Stop the unit and disconnect the power source when not in use. Carry the unit with the motor stopped.
Store unplugged and out of the reach of children.
Do not hang unit so that the switch trigger is depressed.
Do not use multiple cords.
Do not abuse the cord. Never carry the unit by the extension cord or yank extension cord to disconnect unit.
Keep the extension cord clear of operator and obstacles at all times. Do not expose cords to heat, oil, water, or sharp edges.
If the power supply cord is damaged, it must be replaced only by the manufacturer or by an authorized service center to avoid risk.
Save these instructions. Refer to them frequently and use them to instruct others who may use this power tool. If you loan someone this power tool, loan them these instructions also.