ForUsewithSingme | For Use with SplitLine TM |
LineONLY | or SingmeLine |
FWg15.
NOTE: SpHitLineTM can onHybe used with the unnertee[ with the shotted hones. SingHe[ine can be used on either type of inner reel Use Figure 15 to identify the inner tee[ you have.
NOTE: AHwaysuse the correct [ine [ength when installing trimming [ine on the unit. The [ine may not reHease properHyif the [ine is too [ong.
Loop
Fig. 16
Single Line installation
Go To .Step 8 for 5pfitLine 7MInstallation
6.Take approximately 20 feet (6 m) of new trimming line, loop it into two equal lengths, insert each end of the line through one of the two holes in the inner reel (Fig. 16). Pull the line through the inner reel so that the loop is as small as possible.
7.Wind the lines in tight even layers, onto the reel (Fig. 17). Wind the line in the direction indicated on the inner reel. Place your index finger between the two lines to stop the lines from overlapping. Do not overlap the ends of the line. Proceed to step 11.
Fig. 17
SpiitLine TM installation
8.Take approximately 10 feet (3 m) of new trimming line. Insert one end of the line through one of the two holes in the inner reel (Fig. 18). Pull the line through the inner reel until only about 4 inches is left out.
9.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible (Fig. 18).
10.Before winding, split the line back about 6 inches.
11.Wind the line in tight even layers in the direction indicated on the inner reel.
NOTE: Failure to wind the line in the direction indicated wi[[
cause the cutting attachment to operate incorrectly.
Loop
Fig. 18
12.Insert the ends of the line into the two holding slots (Fig. 19).
13.Insert the ends of the line through the eyelets in the outer spool and place inner reel with spring inside the outer spool (Fig. 20). Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the reel.
HoNing Slots
Fig. 19
NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.
14.Hold the inner reel in place and install the bump knob by turning clockwise. Tighten securely.
Spring
"\\\
Fig. 20
12