Remote Control Unit (2)
Battery Replacement
If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.
For more information about collection of batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.
Precautions concerning batteries
Misuse of batteries could cause them to rupture or leak leading to fire, injury or the staining of nearby things. Please read and observe the following precautions carefully.
<Be sure to insert the batteries with correct positive (+) and negative (_) orientations.
<Use batteries of the same type. Never use different types of batteries together.
<Both rechargeable and
<If the remote control will not be used for a long time (more than a month), remove the batteries to prevent them from leaking.
<If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with new ones.
<Do not use batteries of types other than those specified. Do not mix new batteries with old ones or use different types of batteries together.
<Do not heat or disassemble batteries. Never throw batteries into fire or water.
<Do not carry or store batteries with other metallic objects. The batteries could short circuit, leak or explode.
<Never recharge a battery unless it is confirmed to be a rechargeable type.
14
Basic Operation
1 Press the STANDBY/ON button to turn the unit on.
The blue indicator lights.
<Turn on the power of the connected devices before you turn on the
2 Press the SOURCE button repeatedly to select an input source.
The selected source is shown on the display.
Each time the SOURCE button is pressed, the source changes as follows:
CD/SACD
COAX
OPT
USB
LINE1
LINE2 or PHONO*
*When you use LINE2 as PHONO input, select “PHONO” in
<You can also use the INPUT ( / ) buttons on the remote control unit to select a source. If you press the button, the source changes in the opposite order of that shown above.
<When set to COAX, OPT or USB, if no input device is connected to the selected terminal, or this unit is unable to lock with that device, instead of the sampling frequency being shown, the name of the input source will blink. Check the connections.