Snapper M26 Series, 151-3845 manual Sweeper & Hitch Removal

Page 20

2051-3845, 7/04

OPERATION SECTION REMOVING SWEEPER AND HITCH

Sweeper & Hitch Removal

NOTE – Whenever removed, install clevis pins, hitch pins, clips and hardware into the sweeper and hitch for storage.

1.Install stands in storage position and fully lower the attachment lift.

2.Disconnect the drive shaft by pulling back on the locking collar and then pulling the shaft off.

3.Disconnect hydraulic hoses. Disconnect hairpins and remove clevis pins. Slide hitch assembly off the slots on the tractor.

4.Detach the sweeper from the sweeper hitch by moving the shot pins into open position.

5.Lower the hitch to the ground and back out.

Brush head not shown

Lock

Open (Out)

Image 20

Contents M26 Series 51-3845, 7/04 Table of Contents 51-3845, 7/04 Operation Maintenance Serial & Part Numbers Safety Alert Symbol Specifications & FeaturesWarranty Importance of this ManualOperation Read this ManualHazard Definitions Service & Repair Care of Safety Signs LocationsRepresentations of Labels Pinch Point Initial Installation Install Front HitchInstall Long Drive Shaft Brush head not shown Operational Check Snow Removal Operating SweeperSweeper Control General Sweeping Lawn ThatchingLeaf Raking If Driveline Wears Quickly If Material Piles in Front of SweeperIf Brush Wears Unevenly Sweeper & Hitch Removal Lubrication Tractor Air FilterDaily Maintenance Checks Brush ReplacementOn next Maintenance Section Brushreplacement Adjusting Drive Chain Idler Adjusting Brush Contact AreaSafety Labels Replacing Shear Bolt51-3845, 7/04 Parts Part Qty Description Brush Head Parts Section Hitch Assembly #1709659 QTY #1709660 QTY #1960587 QTY #1924366 QTY Item Part Qty Description Appendix Hardware Identification ThankyouforpurchasingaSweepsterproduct.Warrantyprotection One year