Snapper 151-3845, M26 Series manual Service & Repair

Page 9

51-3845, 7/04

9

__________________________________________

SAFETY SECTION

GENERAL INFORMATION

Service & Repair

CAUTION – Do not modify the sweeper in any way. Personal injury could result. If you have questions, contact your dealer or SWEEPSTER.

Repair or adjust the sweeper in a safe area, away from road traffic and other hazards.

Before adjusting or servicing the sweeper – lower the sweeper to the ground, stop the prime mover engine, set the brakes and remove the key from the ignition.

When working on or around the sweeper, lower it to the ground or secure it with transport chains or cylinder-stop locks.

Stop the prime mover engine and cycle control levers to release hydraulic pressure before servicing or adjusting sweeper hydraulic systems.

WARNING – Escaping hydraulic fluid can have enough pressure to penetrate the

skin, causing serious personal injury.

__________________________________________

Image 9
Contents M26 Series 51-3845, 7/04 Table of Contents 51-3845, 7/04 Operation Maintenance Serial & Part Numbers Specifications & Features Safety Alert SymbolWarranty Importance of this ManualRead this Manual Hazard DefinitionsOperation Service & Repair Locations Care of Safety SignsRepresentations of Labels Pinch Point Install Front Hitch Initial InstallationInstall Long Drive Shaft Brush head not shown Operational Check Operating Sweeper Sweeper ControlSnow Removal Lawn Thatching Leaf RakingGeneral Sweeping If Material Piles in Front of Sweeper If Brush Wears UnevenlyIf Driveline Wears Quickly Sweeper & Hitch Removal Tractor Air Filter LubricationBrush Replacement Daily Maintenance ChecksOn next Maintenance Section Brushreplacement Adjusting Brush Contact Area Adjusting Drive Chain IdlerSafety Labels Replacing Shear Bolt51-3845, 7/04 Parts Part Qty Description Brush Head Parts Section Hitch Assembly #1709659 QTY #1709660 QTY #1960587 QTY #1924366 QTY Item Part Qty Description Appendix Hardware Identification ThankyouforpurchasingaSweepsterproduct.Warrantyprotection One year