BEFORE CALLING FOR SERVICE
If you cannot solve your problem after checking the following list, stop using the VCR, unplug it from the outlet, and contact your dealer.
SYMPTOM |
| REMEDY | |
|
|
| |
|
| INSTALLATION PROBLEMS | |
|
|
|
|
No power at the VCR. |
| • | Is the power cord disconnected at the AC outlet? |
|
| • | Is the lock or lock all indicator lit? Refer to the |
|
|
| separate Caution sheet. See your supervisor if the |
|
|
| sheet is not attached to this manual. |
|
| • | Is the timer recording indicator lit? Press the TIMER |
|
|
| REC button on the front panel to cancel timer recording. |
|
|
|
|
The VCR power is on |
| • | Is the lock or lock all indicator lit? Refer to the |
but the unit does not |
|
| separate Caution sheet. See your supervisor if the |
operate. |
|
| sheet is not attached to this manual. |
|
| • | Safety devices are operating. Press the RESET button |
|
|
| on the rear panel using a ballpoint pen or pencil. Turn |
|
|
| power on again. |
|
|
|
|
No picture on the |
| • | Are the monitor and camera connected properly. |
monitor. |
|
| Check the connection. |
|
| • | Is the video cable connected properly? Is the cable |
|
|
| defective? Check the connection and for a snapped |
|
|
| wire in the cable. |
|
|
| |
Picture on the monitor |
| Is the camera focused? Refer to your camera’s user | |
is not clear. |
| manual and focus the camera properly. | |
|
|
| |
| FUNCTION/OPERATION PROBLEMS | ||
|
|
|
|
No operation when |
| • | Is the lock or lock all indicator lit? Refer to the |
any tape operation |
|
| separate Caution sheet. See your supervisor if the |
button is pressed. |
|
| sheet is not attached to this manual. |
|
| • | Is a cassette inserted? |
|
|
| |
The time is wrong |
| Make sure the VCR has AC power supplied continuously | |
even though the VCR |
| for at least 40 hours per week. | |
is used every day. |
|
|
|
|
|
|
|
The power cord was |
| • | Make sure the VCR has AC power supplied |
disconnected for less |
|
| continuously for at least 40 hours per week. |
than 31 days but the |
|
|
|
time has been reset. |
| • | Contents stored in memory may be erased before |
|
|
| the 31 days depending on the charge time of the |
|
|
| power failure compensation circuit. Set the time again. |
|
|
| |
A tape cannot be |
| Is the lock all indicator lit? Refer to the separate Caution | |
loaded. |
| sheet. See your supervisor if the sheet is not attached to | |
|
| this manual. | |
|
|
|
|
70 | Pelco Manual C673M (2/01) |
