INSTALLATION
1.Remove the VCR and all cables from the box.
2.Place the VCR in a suitable location.
3.If installing in a rack, place the VCR in the rack before making cable and power connections. Refer to the documentation included with the rack kit for installation instructions.
4.If you are not using a multiplexer, refer to Figure 1.
•Connect the camera (video output) to the rear of the VCR (video input BNC). Connect the VCR (video output BNC) to the monitor (video input).
•Connect the alarm input to the VCR (ALM IN and GND [ground] terminals).
•If you are using a
5.If you are using a multiplexer, refer to the Connecting the VCR to a Multiplexer section.
ALARM OUTPUT
FROM DEVICE
|
|
|
|
| VIDEO |
| |
|
|
|
|
| IN |
| |
| ALM | RST REC GND | ALM MODE | CLK | CALL |
| |
|
| IN |
| OUT |
|
|
|
| REMOTE | MIC | IN | OUT | IN | OUT | RESET |
|
|
|
| AUDIO |
| VIDEO |
|
MICROPHONE | MIC |
| AUDIO |
| VIDEO | ||
| IN |
| OUT |
| OUT | ||
|
|
|
| ||||
VIDEO IN
AUDIO IN
MONITOR
00429
Figure 1. Typical System Setup
12 | Pelco Manual C673M (2/01) |
