2 – Hardware Installation | Installation Help |
See the Software Installation Guide for the QLA12160 Board on the QLogic web site http://www.qlogic.com/ for detailed instructions on how to install the QLA12160 board’s software drivers.
If the information displayed on your monitor is not correct and you have checked the QLA12160 board’s configuration, see section 3 for troubleshooting information.
2.7
Installation Help
If your system has an IDE fixed disk device, be sure to program the system BIOS to point to the appropriate boot drive. If your system does not have an IDE disk device, the first bootable SCSI disk device configured (the one with the lowest SCSI ID) is assigned device number 80 and is the boot device.
For a motherboard BIOS that does not support SCSI disk booting, you can use settings in Fast!UTIL to select the system’s boot device attached to the QLA12160 board. If the boot device is a
SCSI ID numbers must be unique; otherwise, the BIOS list of SCSI devices displayed on your monitor is not correct. For example, if you give one of your devices the same SCSI ID as the QLA12160 board, that device is listed for all SCSI IDs; or if you have two devices with the same SCSI ID, only one of the devices is listed. If the BIOS list is not correct, power down the computer and check the configuration. Be sure to check the QLA12160 board, which uses SCSI ID 7. If you do not see your device listed on the BIOS listing, see section 3.
If you do not have an IDE drive, set the motherboard BIOS parameters to None or Not Installed. The ROM BIOS on the SCSI controller automatically configures the SCSI peripherals.
If the QLA12160 board is on a SCSI bus with any
