Pelco TLR3168 operation manual Quick Start, Basic Start, Additional Items

QUICK START

BASIC START

NOTE: This section is intended for people experi- enced in working with time-lapse recorders and installing CCTV systems. (However, you might want to take a few minutes to review the material in the General section.)

1.Decide where to locate the VCR. Do all system hookups first (camera, multiplexer, etc.) if you are installing the VCR where you cannot access its rear panel.

2.Connect the VCR to other equipment (refer to the Installation and Connecting the VCR to a Multiplexer sections.)

3.Set the time and date with the power off by pressing the MENU button for more than three seconds and then adjusting the time and date on the fluorescent display. (Refer to the Adjusting the Clock section.) Skip if you do not want to set the time and date.

4.Plug in the VCR and press the POWER button.

5.Insert a T-120 or T-160 tape. Refer to Table D for recording times.

6.Put the VCR in the recording mode you want by pressing the REC/PLAY MODE + and

– buttons. Watch the fluorescent display. Set the recording speed to 6H, L18H, L30H, 48H, 72H, 96H, 120H, 168H, or 0H for T-120 tape or to 8H, L24H, L40H, 64H, 96H, 128H, 160H, 224H, or 0H for T-160 tape.

7.Press REC to begin recording. Press STOP to stop.

8.Turn the SHUTTLE ring right to fast forward and left to rewind. Press STOP to stop. Press PLAY to play back the tape.

9.Refer to the Initial Testing section for information on testing.

ADDITIONAL ITEMS

You can also incorporate the following programming steps for more than a basic quick setup.

•If desired, set the tape end and quasi v-sync options (refer to the First Time Set Up Menu section).

•If desired, set the display mode and time and date size options (refer to the Display Menu section).

•If desired, program for timer recording (refer to the Recording Set Up Menu section).

•If desired, program for alarm recording mode and duration (refer to the Recording Set Up Menu section).

•If desired, refer to the Rear Terminal Menu section to program for call out (refer to the Series Recording section), clock out, operation of the mode out terminal, and operation mode of the REC IN terminal.

10 Pelco Manual C673M (2/01)