Snapper M26 Series, 151-3845 manual Daily Maintenance Checks, Brush Replacement

2251-3845, 7/04

MAINTENANCE SECTION

DAILY MAINTENANCE/BRUSH REPLACEMENT

Daily Maintenance Checks

Hardware – Check and tighten all hardware on the sweeper, including factory-installed hardware.

Brush Contact – Check brush contact. (See Adjusting Brush Contact Area, page 25.)

__________________________________________

Brush Replacement

Replace sections when worn to 14 in. (356 mm) in diameter.

NOTE – Replacing brush sections can be accomplished more easily with the sweeper mounted on the tractor than with it on the ground.

1.Remove the chain guard (figure 1) from the right- hand side of the brush head.

2.Disconnect the drive chain (figure 2) at the master link. Remove the chain from the large sprocket.

3.Loosen 2 set screws on each lock collar located at each end of the brush core (figures 3 and 4).

4.Remove the chain guide plate (figure 5).

Figure 2

Drive End

Figure 3

Bearing End

Figure 4

Figure 1

Figure 5