J. DW: Illuminates when the dual watch mode is enabled.
K. AM: Indicates the CB mode is activated.
L. “F”: Indicates the function button has been activated. The function mode allows use of the modes inprinted on the function buttons face.
M. “M/1”: Indicates the memory channel selection.
N. SCAN: Illuminates to indicate the scan mode is activated.
O. WX: When visible indicates your transceiver is in the weather receive mode. Select the appropriate channel with the up/down buttons.
5.Hand Strap Mount: Attach the included hand strap to this point.
6.Mic/Spk: Plug in an optional speaker/microphone in this jack. The Midland model
7.LIGHT button: Press and release will cause the display backlight to turn on. It will automatically shut off after a few seconds.
8.”LCR’’ button: Pressing this button will recall the last selected channel.
9.“F” button: This is a dual function button. Press and release to activate the “M1- M5” memory selections or for memory programming. Press and hold will cause the display to toggle between channel number and frequency readout.
10.“PTT” button: Press to activate transmit.
11.”Channel UP” button: To skip to the next channel in CB or weather mode. Keeping this button pressed causes rapid incrementing.
12.“Channel DOWN”: To skip to the previous channel in CB or weather mode. Keeping this button pressed causes rapid incrementing.
13.“Control buttons”:
a.“M1 CH9/19 Button”; Press this button and release to select emergnecy channel 9.
Press and release again and highway channel 19 will be selected. Press and release
again will | cause return to the original channel. |
To select memory channel 1; Press the “F” function button and release. Then press
the “M1” button and release, memory channel 1 will be selected.
To program memory channel 1; Select the desired channel to be in memory 1. Press
and | release the “F” function button. Press and hold the “M1” button until a “beep” is |
heard | and the M1 icon is displayed. The selected channel is now programmed in |
memory 1.
b.“M2 DW Button”; To program the 2 dual watch channels, select the first channel.
Press | and hold the “DW” dual watch button until a “beep” is heard and the DW icon | ||
begins | flashing. While the DW icon is flashing select the second channel, then press | ||
and hold | the DW button again until a “beep” is heard and the DW icon stops | ||
flashing. The receiver | will scan between the 2 programmed dual watch channels. | ||
To stop dual watch press the “DW” button. To resume dual watch press the “DW” button again.
To select memory channel M2 press and release the “M2” button.