Section 3 - MAINTENANCE
3.2.3.CHECK MOWER DRIVE BELT
1.Drive Belt Cover Removal
a.Lower deck to lowest setting.
b.Remove knobs that secure the deck cover. See Figure 3.3.
c.Remove cover to gain access to deck belt.
REMOVE
FOUR
KNOBS
REMOVE
DECK COVER
FIGURE 3.3
2. Checking Belt Tension
The idler and spring provide proper belt tension and require no adjustment. If belt is frayed, slit, severed or belt strands exposed, replace belt before operating mower.
3.3AFTER EVERY 25 OPERATING HOURS
3.3.1.ENGINE
1. Engine Oil
Change engine oil. Refer to Section “CHANGE ENGINE OIL”. Refer to engine owner’s manual for oil specifications.
2. Air Filter
Refer to engine owner’s manual for service instructions.
3.Radiator - SEE WARNING
a.Clean radiator debris screen and cooling fins thoroughly. Refer to engine owner’s manual for service instructions.
b.Check coolant level in reserve tank.
3.3.2.MOWER COMPONENTS
1.Mower Drive Belt
No adjustment required. Replace belt as needed.
2. Mower Blade
Check blade for sharpness, wear, damage, and torque. Refer to Section “MOWER BLADE REPLACEMENT”.
3. Mower Deck Levelness
Check mower deck for proper levelness. Adjust as required. Refer to Section “MOWER DECK ADJUSTMENT – LEVELNESS”.
4.Cleaning Mower Deck
a.Remove key from ignition switch.
b.Remove spark plug wire(s) and secure away from spark plug(s). GAS ENGINE ONLY.
c.Raise mower deck to its highest setting. It may be necessary to raise mower deck higher using a hydraulic floor jack. Secure deck with safety blocks.
d.Clean underside of mower deck, removing all accumulation of grass clippings and debris.
e.Clean top of deck, removing all grass clippings and debris.
5.Mower Blade Spindle - Lubrication
a.Remove four knobs that secure the deck cover.
b.Remove cover to gain access to lubrication fitting located on the top of deck below deck pulleys. Lubricate with Kendall NLGI No. 2 lithium grease or equivalent, from
agrease gun until grease purges from vent located on spindle housing underneath deck. See Figure 3.4.
DECK PULLEYS
LUBRICATE
SPINDLE
ASSEMBLIES
FIGURE 3.4
6.Mower Deck Linkage - Lubrication Lubricate all mower deck linkage pivot points with a light coat of motor oil.
WARNING
DO NOT remove cap from radiator when engine and coolant are hot. Coolant is pressurized. Severe burns could result.
15