Snapper CP216019KWV, CRP216019KWV, CP215519HV Product Specifications Common Service Parts

Page 28

21” STEEL DECK

WALK MOWERS COMMERCIAL MODELS SERIES 19

Product Specifications

 

Common Service Parts

Part Number

Deck Size

21 in

Cutter Blade (Ninja - Quad)

7026407

Height of Cut

1.25 - 4 in

Cutter Blade (Air Lift Compatible)

7019795

Transmission Type

Gear

Drive Belt (Engine)

7046784

Ground Speed

1 - 4 mph

Drive Belt (Transmission)

7012354

Engine Power (Kawasaki)

6.0 hp (gross)

Parts Manual - Recycling (‘R’) Models

7006156

Engine Power (Honda)

5.5 hp (gross)

Parts Manual

7006155

Engine Displacement (Kawasaki)

180 cc

 

 

 

 

Engine Displacement (Honda)

160 cc

 

 

Fuel Tank Capacity (All)

2.1 qt

 

 

Engine Power Rating Information: The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating perform- ance has been obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment (actual "on-site" or net power). This difference is due to a variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.

Snapper Products

 

535 Macon Street

 

McDonough, GA 30253

1-800-935-2967

26

www.snapper.com

Image 28
Contents Steel Deck Walk Mowers Commercial Models Series Date of Purchase Retailer Retailers Phone Number Equipment EngineTable of Contents Protection for Children Slope OperationPreparation Preparation From Previous ColumnMaintenance and Storage Safe Handling of Gasoline From PreviousOperation Operation From Previous ColumnFeatures and Controls Features and ControlsOperation Pre-Start Check List Engine and BladeOperation Handle Height AdjustmentPropelling the Mower Recycling Operation Cutting Height AdjustmentRemoving the Recycling Cover Installing the Discharge Deflector Installing the Grass Bag AdapterInstalling the Recycling Plug BACInstalling the Grass Bag Dumping the Grass BagMaintenance Maintenance Introduction Service After First 5 HoursCheck Grease Level in Transmission Change Engine OilService Periodic MaintenanceStorage Procedure Mower Blade Replacement Standard Blade Wear LimitNinja Blade Wear Limit Blade SharpeningWheel Drive Control Adjustment Self-Propelled Models Only Driven and Drive Disc Service Cleaning Drive Disc & Driven DiscDrive Spring Repair/Replacement Driven Disc AdjustmentDriven Disc Ring Replacement Proper driven disc adjustmentDriven Disc Bearing Replacement Replacing the driven disc bearingEngine Drive Belt Replacement Stretch Type Belts Belt ServiceReplacing the Bearing On the Pulley End Of the Hex Shaft Transmission Poly-V Belt Replacement ProcedureService Schedule Maintenance/Replacement PartsTroubleshooting Probable Cause Corrective ActionYear Limited Warranty Page Page Page Product Specifications Common Service Parts Part Number