Snapper CRP216019KWV, CP216019KWV, CP215519HV specifications Installing the Recycling Plug, Bac

Page 11

Operation (Continued)

!

WARNING

!

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

Installing the Recycling Plug

1.Install the recycling plug (A, Figure 13) if recycling is desired after the bag adapter is installed. Install the recycling plug completely and securely into the bag adapter (B).

IMPORTANT: Install the grass bag as a safeguard.

Installing the Grass Bag Adapter (Continued)

Flip the pulley over so that the bushing flange is under the pulley. The bushing will act as a washer between the pulley and the standoff.

Reassemble the pulley to the bag adapter, and install the supplied replacement bolt, fitted with the thread sleeve, into the recoil cover. Tighten all hardware securely.

BAC

D

Figure 12: Installing the adapter standoff

5.Route the recoil rope around the outside of the rope guide pulley (C, Figure 12).

Note: The recoil rope may need to be slackened. Refer to the section entitled “Handle Assembly”.

A

B

Figure 13: Installing the recycling plug

2. Refer to the section entitled “Recycling Operation”.

Operation

!

WARNING

!

DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Steel Deck Walk Mowers Commercial Models Series Engine Date of Purchase Retailer Retailers Phone Number EquipmentTable of Contents Preparation From Previous Column Protection for ChildrenSlope Operation PreparationOperation From Previous Column Maintenance and StorageSafe Handling of Gasoline From Previous OperationFeatures and Controls Features and ControlsEngine and Blade Operation Pre-Start Check ListPropelling the Mower Handle Height AdjustmentOperation Removing the Recycling Cover Cutting Height AdjustmentRecycling Operation Installing the Grass Bag Adapter Installing the Discharge DeflectorBAC Installing the Recycling PlugDumping the Grass Bag Installing the Grass BagChange Engine Oil Maintenance Maintenance IntroductionService After First 5 Hours Check Grease Level in TransmissionStorage Procedure MaintenanceService Periodic Blade Sharpening Mower Blade ReplacementStandard Blade Wear Limit Ninja Blade Wear LimitWheel Drive Control Adjustment Self-Propelled Models Only Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementProper driven disc adjustment Driven Disc Ring ReplacementReplacing the driven disc bearing Driven Disc Bearing ReplacementReplacing the Bearing On the Pulley End Of the Hex Shaft Belt ServiceEngine Drive Belt Replacement Stretch Type Belts Procedure Transmission Poly-V Belt ReplacementMaintenance/Replacement Parts Service ScheduleProbable Cause Corrective Action TroubleshootingYear Limited Warranty Page Page Page Part Number Product Specifications Common Service Parts
Top Page Image Contents