Snapper CRP216019KWV, CP216019KWV, CP215519HV Cutting Height Adjustment, Recycling Operation

Page 9

Operation (Continued)

!

WARNING

!

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

Cutting Height Adjustment

1.Pull the height adjusting latch (A, Figure 7) outward and move to the desired cutting height.

A

Figure 7: Adjusting cutting height

2.Set all wheels at the same cutting height. The highest cutting position is Notch 7 (Figure 8). The lowest cutting position is Notch 1.

1.25 in 4.00 in

Figure 8: Cutting height settings (approximate)

Recycling Operation

Note: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.

1.Set all wheels in the highest cutting position (Notch 7). Refer to the Section entitled “Cutting Height Adjustment”.

2.Move the engine speed control to the fast (Rabbit) position.

3.Move the ground speed control to the slowest speed setting.

4.Proceed mowing slowly. If the grass is very dense, lower each rear wheel latch one notch lower than the front wheel latches to improve recycling performance.

Note: The recycling cover should remain on the machine at all times, unless alternate discharge operations are desired, such as side discharging or bagging.

Removing the Recycling Cover

1.Remove the nuts (A, Figure 9) securing the recycling cover (B) to the mower deck.

2.Remove the cover.

B

A

Figure 9: Removing the recycling cover

Operation

!

WARNING

!

Stop engine and mower blade by releasing the blade control before adjusting cutting height.

7

Image 9
Contents Steel Deck Walk Mowers Commercial Models Series Engine Date of Purchase Retailer Retailers Phone Number EquipmentTable of Contents Slope Operation Protection for ChildrenPreparation Preparation From Previous ColumnSafe Handling of Gasoline From Previous Maintenance and StorageOperation Operation From Previous ColumnFeatures and Controls Features and ControlsEngine and Blade Operation Pre-Start Check ListHandle Height Adjustment OperationPropelling the Mower Cutting Height Adjustment Recycling OperationRemoving the Recycling Cover Installing the Grass Bag Adapter Installing the Discharge DeflectorBAC Installing the Recycling PlugDumping the Grass Bag Installing the Grass BagService After First 5 Hours Maintenance Maintenance IntroductionCheck Grease Level in Transmission Change Engine OilMaintenance Service PeriodicStorage Procedure Standard Blade Wear Limit Mower Blade ReplacementNinja Blade Wear Limit Blade SharpeningWheel Drive Control Adjustment Self-Propelled Models Only Cleaning Drive Disc & Driven Disc Driven and Drive Disc ServiceDrive Spring Repair/Replacement Driven Disc AdjustmentProper driven disc adjustment Driven Disc Ring ReplacementReplacing the driven disc bearing Driven Disc Bearing ReplacementBelt Service Engine Drive Belt Replacement Stretch Type BeltsReplacing the Bearing On the Pulley End Of the Hex Shaft Procedure Transmission Poly-V Belt ReplacementMaintenance/Replacement Parts Service ScheduleProbable Cause Corrective Action TroubleshootingYear Limited Warranty Page Page Page Part Number Product Specifications Common Service Parts