Snapper CRP216019KWV, CP216019KWV, CP215519HV specifications Driven Disc Bearing Replacement

Page 19

Maintenance (Continued)

!

WARNING

!

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

Driven Disc Ring Replacement (Continued)

2.Using needle nose pliers, unhook the drive spring (A, Figure 31) and slide the driven disc assembly off the hex shaft.

3.Remove the five machine screws (A, Figure 32) and plate (B) which secure the rubber ring (C) to the driven disc hub (D).

4.Install a new rubber ring.

5.Reverse the above procedures for reassembly and installation of the driven disc assembly.

A

Driven Disc Bearing Replacement

If the driven disc bearing requires replacement, replace the bearing as follows:

1.Remove the driven disc assembly. Refer to the Section entitled “Driven Disc Replacement”.

2.Remove the snap ring (A, Figure 33) that secures the driven disc hub (B) to the thrust plate.

3.Slide the driven disc hub out of the bearing (C).

5.Remove the four screws, and replace the bearing.

6.Reassemble the components in reverse order.

NOTE: Be sure to replace the shim washer (D) when reassembling the driven disc assembly.

A

C

D

B

Maintenance

Figure 33: Replacing the driven disc bearing

Figure 31: Removing the driven disc assembly

A

B

D

C

Cross Section

Figure 32: Replacing the driven disc rubber ring

17

Image 19
Contents Steel Deck Walk Mowers Commercial Models Series Engine Date of Purchase Retailer Retailers Phone Number EquipmentTable of Contents Preparation From Previous Column Protection for ChildrenSlope Operation PreparationOperation From Previous Column Maintenance and StorageSafe Handling of Gasoline From Previous OperationFeatures and Controls Features and ControlsEngine and Blade Operation Pre-Start Check ListOperation Handle Height AdjustmentPropelling the Mower Recycling Operation Cutting Height AdjustmentRemoving the Recycling Cover Installing the Grass Bag Adapter Installing the Discharge DeflectorBAC Installing the Recycling PlugDumping the Grass Bag Installing the Grass BagChange Engine Oil Maintenance Maintenance IntroductionService After First 5 Hours Check Grease Level in TransmissionService Periodic MaintenanceStorage Procedure Blade Sharpening Mower Blade ReplacementStandard Blade Wear Limit Ninja Blade Wear LimitWheel Drive Control Adjustment Self-Propelled Models Only Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementProper driven disc adjustment Driven Disc Ring ReplacementReplacing the driven disc bearing Driven Disc Bearing ReplacementEngine Drive Belt Replacement Stretch Type Belts Belt ServiceReplacing the Bearing On the Pulley End Of the Hex Shaft Procedure Transmission Poly-V Belt ReplacementMaintenance/Replacement Parts Service ScheduleProbable Cause Corrective Action TroubleshootingYear Limited Warranty Page Page Page Part Number Product Specifications Common Service Parts