Snapper 7800601, 7800600, 7800602, 7800597, 7800596 specifications Troubleshooting

Page 22

Troubleshooting

Troubleshooting

PROBLEM

 

 

PROBABLE CAUSE

 

CORRECTIVE ACTION

Engine Will Not Start Using

1.

Fuel tank empty.

 

1.

Fill fuel tank with fresh fuel.

Recoil Starter

2.

Spark plug wire disconnected.

2.

Place spark plug wire onto spark plug.

Engine Stalls or Stops After

1.

Blade control is released or is not being held

1.

Blade control should be held securely against handle

Running

securely against handle.

 

at all times during operation of mower.

 

2.

Fuel tank empty.

 

2.

Fill with fuel to proper level.

 

3.

Engine air pre-cleaner and or air cleaner dirty.

3.

Clean free of all debris.

 

4.

Spark plug defective or gap set improperly.

4.

Service spark plug.

 

5.

Water, debris or stale fuel in fuel system.

5.

Drain and clean fuel system.

Engine Loses Power

1.

Engine air pre-cleaner or air cleaner dirty.

1.

Clean or replace filters.

 

2.

Spark plug faulty.

 

2.

Service spark plug.

 

3.

Water, debris or stale fuel in fuel system.

3.

Drain and clean fuel system.

Excessive Vibration

1.

Damaged, out of balance or bent mower blade.

1.

Service mower blade.

 

2.

Loose blade components.

2.

Service and tighten loose parts.

 

3.

Loose or missing air lift (if equipped).

3.

Replace air lifts. Tighten to proper torque.

 

4.

Lumpy or frayed belt.

 

4.

Replace belt.

Mower Will Not Move Loss

1.

Build-up of debris on or around wheel drive

1.

Clean debris.

Of Traction (Self-Propelled

components.

Reproduction

 

 

 

 

Models)

2.

Driven disc slipping.

 

2.

Clean r replace driven disc.

 

 

 

3.

Drive belt requires replacement.

3.

Replace dr ve belt.

 

4.

Damaged transmission.

 

4.

C n act auth rized dealer.

 

 

 

Not

 

 

Cutting Grass Improperly

1.

Cutting height too low or high.

1.

Adjust cutting height.

 

2.

Engine speed too sl w.

 

2.

Move engine speed control to ‘Fast’ position.

 

3.

Forward ground speed

fast.

3.

Move ground speed control to a slower speed.

 

4.

Terraced cut, side to side.

4.

Adjust height of cut with height adjust levers.

 

5.

Excessive deck pitch, front to rear.

5.

Adjust height of cut with height adjust levers.

 

6.

Cutting blade dull or damaged.

6.

Sharpen cutting edges or replace blade.

Poor Grass Discharge

1.

Engine speed too fast.

 

1.

Move engine speed control to ‘Fast’ position.

 

2.

Forward speed too fast.

 

2.

Move ground speed control to a slower speed.

 

3.

Grass is wet.

 

3.

Mow when grass is dry.

 

4.

Excessively worn or damag d blade.

4.

Service mower blade.

 

5.

Build up of grass clippings and debris under deck.

5.

Clean deck.

 

6.

Improper blade install

on deck.

6.

Install proper blade.

 

7.

Blade installed improperly on deck.

7.

Install blade properly.

Oil Leaking

1.

Leaking engine case.

 

1.

Contact authorized dealer.

 

 

 

 

 

2.

Check and tighten drain plug.

 

 

 

 

 

3.

Make sure dip stick or oil filler cap is securely in

 

 

 

 

 

place.

22

www.snapper.com

Image 22
Contents Not Manual No Rev. ‘-’, 10/20/2009Snapper is a trademark Briggs & Stratton Power Products Group, LLCJefferson, WI, USA Milwaukee, WI, USA. All Rights Reserved Table of Contents From Previous Column Important Operator Safety InstructionsProtection for Children Preparation Slope OperationMaintenance and Storage Safe Handling of Gasoline OperationFeatures and Controls Features and ControlsEngines Operation Pre-Start Check List Starting and OperationOperation Stopping Handle Height AdjustmentOperation Propelling the MowerOperation Recycling Operation Removing the Recycling CoverInstalling the Discharge Deflector Door Type Bag Installing the Grass BagInstalling the Recycling Plug Grass Catcher bags used Snapper products are madeMaintenance Maintenance Maintenance IntroductionService After First 5 Hours Check Grease Level in TransmissionService Periodic MaintenanceAge Pr cedure Standard Blade Wear Limit Mower Blade ReplacementBlade Sharpening Wheel Drive Control Adjustment Self-Propelled Models Only Reprod Capscrew UctionDriven and Drive Disc Service Drive Spring Repair/ReplacementUction Driven Disc AdjustmentReprod From the outside edge of the drive disc B If the rubberDriven Disc Replacement Belts Maintenance Belt ServiceHex Shaft Replacing the Bearing On the Pulley EndBelts Transmiss on P ly-V Belt ReplacementDriven Disc Replacement for driven disc removal Procedure Drain the fuel tank before tipping the mower. Do not tiltService Schedule Maintenance/Replacement PartsTroubleshooting TroubleshootingThere is no other express warranty Improper electrolyteNot For Not For Not For Not For Snapper Products Macon Street McDonough, GA
Related manuals
Manual 28 pages 4.23 Kb

7800596, 7800597, 7800601, 7800602, 7800600 specifications

Snapper has long been known for its quality and innovation in outdoor power equipment, and their recent models, specifically the Snapper 7800596, 7800597, 7800600, 7800601, and 7800602, showcase this legacy perfectly. These lawn mowers combine power, ease of use, and technology to create a superior mowing experience.

The Snapper 7800596 and 7800597 are ideal for homeowners who desire robust performance. Both models are powered by a strong engine that offers reliable starts and efficient mowing. They feature a durable steel deck, ensuring longevity while withstanding the rigors of routine use. A standout feature is their adjustable cutting height, allowing users to choose between various grass lengths, ensuring a tailored cut for different lawn conditions.

Moving on to the Snapper 7800600 and 7800601, these models come equipped with advanced technologies that enhance user experience. The inclusion of a self-propelling mechanism significantly reduces the effort required by the operator, making mowing less of a chore. Furthermore, these mowers are designed with innovative blade technology, which optimizes cutting efficiency and grass discharge, resulting in a cleaner lawn finish.

The Snapper 7800602 rounds out this impressive lineup with its standout feature: a powerful battery-operated option. This model harnesses the latest in battery technology, ensuring longer run times and quicker charging capabilities. Moreover, it's environmentally friendly, producing zero emissions while providing the same power and performance expected from gas-powered models.

All models come with ergonomic handles for comfortable operation, and their lightweight design makes them easy to maneuver around obstacles in the yard. Additionally, snap-on components make maintenance a breeze, which is a vital feature for those seeking hassle-free ownership.

In summary, the Snapper 7800596, 7800597, 7800600, 7800601, and 7800602 models bring together cutting-edge technology, robust power, and user-friendly features. Whether you need a gas-powered mower for durable performance or an electric option for silent and clean operation, Snapper ensures that you'll find a suitable lawn mower among these well-engineered machines. With Snapper, lawn care becomes a task of ease and enjoyment, making it the perfect choice for homeowners looking to maintain their outdoor space efficiently.