Section 2 - OPERATING INSTRUCTIONS
2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE 2.4.4. PARK BRAKE
1.Engage park brake by pushing clutch/brake pedal “DOWN” and moving the park brake lever to the “ON” position. While holding the park brake lever “ON”, release clutch/brake pedal to set park brake. See Figure 2.16.
PUSH CLUTCH/BRAKE
PEDAL ALL THE WAY
DOWN
MOVE PARK
BRAKE LEVER
TO “ON”
FIGURE 2.16
2.Release park brake by pushing down on the clutch/brake pedal to release park brake lever. See Figure 2.17.
PUSH CLUTCH/BRAKE
PEDAL ALL THE WAY
DOWN
2.5.CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any one of six positions using deck lift lever. When in desired height of cut, release latch, then try to move deck lift lever to ensure lift lever latch is fully engaged. See Figure 2.18.
DECK LIFT
LEVER
LIFT LEVER
LATCH
FIGURE 2.18
WARNING
DO NOT park machine on slopes.
FIGURE 2.17
11