Snapper 1695164 manual Bag, Chute and Tube Installation

Page 10

Bag, Chute and Tube Installation

Bag, Chute and Tube Installation

INSTALL COLLECTOR BAGS

1.Raise the cover (A, Figure 12).

2.Slide collector bags (B) onto tubes (C) with the white bar towards the rear.

Note: It may be necessary to fold seat forward to allow cover to stay in the raised position.

A

C

B

LOWER DISCHARGE CHUTE INSTALLATION

1.Lift discharge deflector up (E, Figure 13).

2.Place the front hole of the lower chute (A) onto carriage bolt (C) as shown. Slide front edge of lower chute (A) under hinge bracket (G).

3.Place the rear hole of the lower chute (A) onto carriage bolt (F) as shown.

4.Secure knob (B) onto carriage bolt (C) as shown.

5.Secure wing nut (D) onto carriage bolt (F) as shown.

Figure 12. Install Collector Bags

A.Cover

B.Collector Bags

C.Tubes

E

A

D

F

G

B

C

Figure 13. Install Lower Discharge Chute

A.Lower Chute

B.Knob, 5/16-18

C.Front Carriage Bolt, 5/16-18 x 3/4

D.Wing Nut, 5/16

E.Discharge Deflector

F.Rear Carriage Bolt, 5/16-18 x 3/4

G.Hinge Bracket

8

Image 10
Contents Clean Sweep Twin Catcher OPERATOR’S ManualPage Table of Contents Safety Rules Information Attachment DecalAfter Operation Before OperationMowing with the Catcher Storing The Grass CatcherInitial Installation Hitch InstallationPin Installation Component InstallationLatch Installation Install Channel Assembly Hitch PinTube Installation Install Cover to Channel Assembly Pin Hair PinBag, Chute and Tube Installation Bag, Chute and Tube InstallationTube and Chute Installation Normal Removal & Installation Collector InstallationNormal Removal Collector Removal