Removing & Re-attaching Grass Catcher
A
B
D
C
Figure 1. Remove the Cover
A. | Cover | C. Hinge |
B. | Hinge Pin | D. Hair Pin Clip |
A |
Figure 2. Remove the Bags
A. Bags
REMOVING & RE-ATTACHING THE GRASS CATCHER
Removing the Grass Catcher & tubes
1.Remove the hair pin clips (D, Figure 1) and hinge pins (B) and remove the cover (A).
2.Remove the bags (A, Figure 2) by lifting them off their hooks. Empty any grass out the bags.
A |
C |
B |
D |
Figure 3. Install Back Plate |
|
A. Back Plate & Support | C. Hitch Plate |
B. Hair Pin | D. Rod |
A
| C |
B | To Turbo |
| |
| Blower |
3.Unclip middle and lower tube assembly (B, Figure 4) and remove from turbo and upper tube.
4.Warning: Back plate (A) will fall when rod (D) is removed. Remove the hair pin (B, Figure 3) and rod
(D) while holding back plate (A).
5.Lift the back plate and support assembly (A, Figure 3) off hitch plate (C).
Figure 4. Assemble Tubes
A. Upper TubeC. Clip
B. Middle & Lower Tube
WARNING
OPERATION WITHOUT TURBO & CATCHER
For operation without turbo, the mower deflector MUST be properly installed in the down position and retained by the spring latch (see turbo operator’s manual).
14