Snapper 1726794 manual Install Deflector, Models

Page 7

Initial Turbo Installation

Install Deflector

1.See Figure 6. Drill four 13/64” holes from the bottom of the deflector at the pre-molded drill points (A, bot- tom of deflector).

2.Attach the deflector to the support rod wire-form using four #10-14 x 3/4 truss head screws and nylock nuts.

Install Belt Guide

1.See Figure 7 & 8. Locate the taptite screw that will be replaced by capscrew (C). Remove and discard the taptite screw

2.Assemble the 5/16-18 x 1-1/2 capscrew (C), lock- washer (E), washers (B), belt stop (D) and spacer

(A).

3.Secure the belt stop assembly to the deck in the loca- tion shown.

Note The belt stop (D, Figures 7 & 8) is located and ori- ented differently in 44” and 50” applications. For all applications, when turbo is installed, beld stop (D) should be outside the belt 1/8” away from the backside of the belt.

B

A

C

Figure 6. Install Deflector

A. 13/64 Hole Locations C. Screws, #10-24 x 3/4 B. Nylock Nuts

50” Models

E

C

D

B

A

Figure 7. Install Belt Guide

 

A. Spacer

 

D. Belt Stop

B. 5/16 Washers

 

E. Lockwasher,

C. Capscrew, 5/16-18 x 1-1/2

5/16

44” Models

E

C

B D

A

Figure 8. Install Belt Guide

 

A. Spacer

D. Belt Stop

B. 5/16 Washers

E. Lockwasher,

C. Capscrew, 5/16-18 x 1-1/2

5/16

6

Image 7
Contents OPERATOR’S Manual Clean Sweep Triple CatcherTable of Contents Safety Rules Information General Operating Instructions Installation Install Deflector Hinge Assembly Install Discharge BaffleDeflector Removal Models Install DeflectorInstall Turbo Drive Pulley Install Idler Assembly & Belt CoverInstall Anchor Bracket Install Turbo Belt Install Belt Cover PlateInstall Mounting Bracket Install Turbo Drive Belt Install Turbo BlowerSecure Belt Cover Front Weight Carrier Installation Initial Counter Balance & Weight Carrier InstallationInitiai Hitch & Tube Installation Assemble Tubes & Deflector Initial Hitch & Tube InstallationAssemble Catcher Bags Install CoverRemoving & Re-attaching Grass Catcher Re-attaching the Grass Catcher Removing and Re-attaching Grass CatcherFront Weight Carrier Group Clean Sweep Triple Catcher Series Triple Catcher Group Consumer Z Triple Bagger 986509 Tube & Hitch Group Consumer Z Triple Bagger 986506 Turbo Mounting Group 986508 Turbo Mounting Group Bracket Z Hardware Identification & Torque Specifications