Snapper 1691810, 1691998 manual Installation Front Cut Riders

Installation - Front Cut Riders
NOTES
1. Two spacers are packaged with the turbo
blower. Installation on the Front-Cut Rider
requires use of the l/2” spacer (see step 14).
The 4-l/16” spacer will not be used.
2. The replacement right hand belt cover (seestep
15),along with thenew3/8-16x2-1M”capscrew
for the right hand idler pulley (see step 4) is
packaged with the collection system.
INSTALLATION
1. Remove right hand mower belt cover by
removing flat washer and flange nut (A) and
front taptite screw (B). Loosen hardware at
center location (C). Belt cover can bediscarded
	Figure 1. (Later Mode\1 Shown)
as new belt cover and arbor cover will replace
	A. Flange Nut
original cover. Save all hardware for installing
	B. Tapttle Screw
new cover.
	C. Mounting Hardware - Center Location
2. Remove the deflector mounting hardware and
reinstall in deflector for future use. Deflector
must be reinstalled if turbo blower is removed
from mower deck.

I	eWARNING
	Use caution when moving spring-loaded idler
	pulley. Spring tension isstrong. Do not remove
	belt from spring-loaded idler pulley. Remove
	belt from left and right hand pulleys.

3.Pull spring-loaded idler pulley away from belt and remove belt from right hand arbor pulley

and idler pulley.

4.Remove the idler pulley capscrew (installed from the top) and install new 3/8-16 x 2-114” capscrew from the bottom. Pulley bracket

mounting hardware may need to be loosened to	,
install 2-l/4” capscrew (A) from bottom. Install
existing flat washer (8) on top of bracket, pulley,	- Pulley
existing flat washer(B), lockwasher(C),and nut		I
(D) to secure capscrew. Install large washer(E)
	F igure 2.
onto capscrew. Capscrew (A), lockwasher (C),
nut (D), and large washer(E) are packaged with	A. 2-114” Capscrew
the collection system.	B. Flat Washer (Existing)
	C. Lockwasher
NOTE	D. Nut
	E. Large Flat Washer, 13/X? x l-l/2X 118
Existing flange nut will be used in step 15 to
secure new belt cover.