installation - Lawn ,Tractors
N O T E
Two spacers are packaged with turbo biower. Installation on tractor requires use of
1.Remove mower deflector and arbor cover as follows:
a.Remove the mower deflector by removing two carriage bolts, lockwashers and nuts. Install this hardware on the deflector for use when blower is removed for side discharge.
b.Remove the right hand arbor cover (A, figure
1)by removing washers and nuts in frontthat hold cover to deck. Also, remove nuts (8) and washers that secure rear tabs to arbor.
2.Slip mower belt off the right hand pulley. Remove the pulley from the arbor by removing capscrew (D, figure 2) and washers (F). Save washers for reinstallation. Use wood block to orevent blade from turning.
N O T E
Later model decks have
2.If capscrew protrudes 5/S” above arbor, new capscrews do not need to be installed
3.Remove brake spring or spring anchor (if equipped) and two taptite screws from arbor at locations A, figure 2. Replace these with two
A. capscrew | D. capscrew |
B. Arbor Bracket | E. Belt Stop, Front |
C. Notch | F. Washers |
4.Before installing arbor bracket (B, figure 2 &A, figure3), removewasherfrom underneath blade brake bracket (rear capscrew). Arbor bracket is same thickness as washer and will replace washer. Loosen the front flange nut and remove the rear flange nut on the blade brake bracket.
N O T E
Rear belt stop should be installed facing inside of deck.
5.Install the arbor bracket (A, figure 3) and rear belt stop (B) as shown. Note the different holes for the 42” and 43” mowers. On the 42” deck, install a jamnut at rear bracket location instead of flange whiz nut. Tighten nut (F) snug only - belt stop will be adjusted in step 8.
Figure 1.
A. Arbor Cover
B. Nut dover
Figure 2.
I.
Figure 3.
A Arbor Bracket | C. CapSxew | E. Lockwasher |
B. Belt Stop | D. Large Washers | F. Jam Locknut |
3