Telex BTR-500/600C operating instructions Pre-Walk-Thru Checklist

Page 23

Pre-Walk-Thru Checklist

Following the instructions fully to this point you have successfully completed the following check- list:

❒Located the base station properly.

❒Connected power to base station transceiver.

❒Connected the 1/2-wave antennas to the base station. Check frequency range of the antenna with the frequency of the base station by cor- rectly matching color codes.

❒For a large system in which a split- ter/combiner (SC-600) is used, make sure the antenna cables are connected to the correct ports and that the main antennas are con- nected to the marked SC-600 ports.

❒Set RF transmit and receive switches on the base stations(s) to match their respective beltpacks.

❒Set transmit mode switch on base station.

❒Set wired intercom type correctly.

❒Set audio channel correctly.

❒Set Telex switch properly.

❒Set Code Switch to a unique code that matches the beltpack. (BTR-600C only)

❒Connected headsets to base stations (if needed) and all beltpacks.

❒Connected the base station to any auxiliary audio, intercom, or external speaker if needed.

❒Installed batteries in the beltpack.

❒If you missed any of the above instructions, go back and complete that instruction before going on.

-20-

Image 23

Contents Telex Table of Contents Customer Service Information FCC Information General Description System FeaturesIntroduction Front Panel Controls and Connections Base Station TransceiverControls and Connections Rear Panel BTR-600C Intercom 1 and 2 Jacks Switch set to TelexIntercom 1 and 2 Jacks Switch set to RTS Base StationAuxiliary Jack BTR-500/600C SpecificationsControls and Connections Headset Jack WiringBeltpack Beltpack Specifications Quantity Descripton Initial Equipment Set-UpUnpacking Antenna ConnectionDistance between Antennas Antenna PlacementAntenna Polarization Keeping Site Clear to Antenna Distance Between base station BeltpackOperating System Near Obstructions Improving Reception and Increasing Range Antenna PlacementRack Mounting RF Transmit/Receive Channel SwitchesBase Station Set-Up LocationDual Listen Switches RF Transmit Mode SwitchIntercom Type Switch Auxiliary Switch Audio Channel SwitchTelex IN/OUT Switch Auxiliary to I/C Switch Program AudioConnecting Base Stations Together Interconnection to a Hard-Wired Intercom SystemAuxiliary to I/C Switch Intercom User Station US-2000A Program Speakers Example Interface to an Audiocom Telex Intercom SystemExample Interface to an RTS Intercom System Intercom Power Supply PS15Dummy Load Power ConnectionAuxiliary Audio Connection Beltpack Set-Up Code Switch TR-600C OnlyConnecting Headset RF Channel Switches and RF Transmit ModeBattery Installation Battery InstallationPre-Walk-Thru Checklist System Operation PowerPush-to-Talk/Lock-to-Talk Switch Local Headset VolumeSidetone Level Dual Listen LevelIntercom Level Auxiliary LevelPush-to-Talk/Lock-to-Talk Power/Local Headset VolumeBattery Check Beltpack OperationSidetone Level Control Microphone GainSingle Base Station Audiocom Telex System Example System ConfigurationsSingle Base Station RTS System Curtain Director RTS Power SupplyExample of Six BTR-500 RTS Systems used by a Production Unit Six Base Station RTS System= Beltpack Position 1 *2 = Beltpack Position Eight Base Station Telex SystemExample of a TR-500 System used at a Publishing Firm Beltpack to Beltpack SystemSingle Beltpack to Single Beltpack System System Walk-Thru Troubleshooting Frequency Interaction Codes Settings and the BTR600CTech Tips Intercom Systems Specifications Battery InformationAccessories and Replacement Parts Customer Service Information FCC Information JAN Made in U.S.A