TROUBLESHOOTING
Reread the sections of this manual to make sure you have completed system
If you are unable to solve the problem, contact the dealer from whom you purchased the system for as- sistance.
PROBLEM | SOLUTION |
| |
|
|
| |
DISTORTION - System’s audio quality seems | Reduce microphone gain | by adjusting | |
distorted at medium to high input levels. | microphone gain control. |
| |
|
| ||
HISS - System seems to produce a “hiss” which is | Check the gain setting on all beltpacks and the | ||
undesirable. | base. They may be too low. |
| |
|
| ||
LOW OUTPUT - System produces a low output | Check the gain setting on both the beltpacks and | ||
level. | the base. They may be too low. |
| |
|
|
| |
FEEDBACK - Moving around area of use | Reduce the gain settings on both the beltpacks and | ||
produces “squeal” or “howl” in various locations | |||
the base. They may be too high. |
| ||
using ext. speakers. |
| ||
|
| ||
|
|
| |
DROPOUTS - When moving around the area of | Make sure both antennas on | the base are | |
connected and follow the location suggestions. | |||
use there seems to be locations where the signal | |||
Change the location of the base unit and antennas | |||
“swooshes” or completely disappears. | |||
or avoid the bad areas with the remote beltpacks. | |||
| |||
|
| ||
| Make sure the Telex beltpack is turned on - this | ||
| will usually eliminate the interfering signal. If not | ||
| using a beltpack, make sure the transmit mode | ||
| switch at the base is in the off position. | ||
INTERFERENCE - System picks up signals |
|
| |
other than wireless Intercoms. | If problems persist with the beltpack on, you will | ||
| probably need to change frequency channels. | ||
| Make sure the base channel switch matches the | ||
| beltpack. |
| |
|
| ||
| Check Transmitter switch on base, use CONT or | ||
| REMOTE position. Check | ||
NO AUDIO from BASE or BELTPACK headsets. | is the switch ON. Make sure beltpack batteries are | ||
| OK. |
| |
|
|
| |
|
|
| |