Snapper SPE131KW, SPE151KW, SPE361, SPE381 Traction Lock Operation, Turning Mower

Page 14

SECTION 3 - OPERATING INSTRUCTIONS

WARNING

Brakes require maintenance. Inspect for proper operation before operating machine. Refer to Section “ADJUSTMENTS, STEERING AND BRAKES”.

WARNING

Machine should always be in forward motion before attempting a turn. DO NOT attempt a turn from a stopped position.

3.7 TRACTION LOCK OPERATION -

3.7.1 TO LOCK

1.Simultaneously squeeze both Traction Levers toward the handle, to stop movement of machine.

2.Using index fingers pull right and left Traction Locks rearward until both Traction Levers are locked in the Traction Locked position.

3.7.2 TO UNLOCK

1.Simultaneously squeeze both Traction Levers firmly against the handle. The right and left Traction Locks will move to the “Unlocked” position. See Figure 3.9.

3.8 TURNING MOWER

3.8.1. GRADUAL RIGHT & LEFT HAND TURN

IMPORTANT: Squeezing the right or left traction lever applies the brake to the right or left wheel. The brake turns the machine right or left.

RIGHT TURN:

1.With machine in motion gradually squeeze the right hand Traction Lever. The machine will turn to the right.

LEFT TURN:

2.With machine in motion gradually squeeze the left hand Traction Lever. The machine will turn to the left.

IMPORTANT! Always make sure that both right and left Traction Locks are in the same position before moving or releasing the Traction Levers.

TRACTION LEVER (LEFT HAND)

TRACTION LOCK LEVER

TRACTION LEVER POSITION

BRAKE POSITION

DRIVE POSITION

LEFT HAND

TRACTION LEVER

(RIGHT HAND - RELEASED POSITION SHOWN)

FIGURE 3.9

FIGURE 3.10

3.9MOWING AND TURNING ON HILLSIDES

1.Always mow hillsides starting at bottom of hill. Mow across slopes, never up and down. Exercise caution when changing directions on slopes. DO

NOT mow steep slopes!

WARNING

DO NOT mow on steep slopes. DO NOT use with any type rider attachment on slopes. DO NOT park machine on slopes.

2.Hillside mowing is accomplished by squeezing Traction Lever on the UPHILL SIDE of machine. This helps reduce side slipping of mower.

3.When turning mower on hillsides, always turn toward the UPHILL SIDE of mower for better control and balance.

14

Image 14
Contents PRO Gear Express Walk Behind Mowers MID-SIZE Series Model Number ExplanationSlope Operation Important Safety InstructionsProtection for Children PreparationSafe Handling of Gasoline OperationMaintenance Table of Contents Nomenclature FamiliarizationIntroduction Safety Messages and Symbols Keep Children and Others OUT of the Mowing AreaImportant Safety and Operating Instructions Controls Before Operating Safety Interlock System ChecksOperating Instructions Stopping MachineEngine Start Engine AS Follows PRE-START Check ListStarting & Operating On next To Reverse Direction Reverse OperationStopping Machine Mowing and Turning on Hillsides Traction Lock OperationTurning Mower Adjusting Blade on Cutter Spindle Cutting Height AdjustmentAdjusting Caster Wheels Adjusting Fixed Deck Attachment Side Profile of UnitTroubleshooting Symptom Problem SolutionMower Troubleshooting Hours Procedure CommentsTraction LEVERS/RODS AdjustmentsSTEERING/BRAKES Transmission Shift Lever Adjustment Handle HeightTransmission Parts & Service Power Unit ServiceReplacement Parts Traction Belt Removal & Replacement Mower Attachment ServiceTransmission Belt REMOVAL/REPLACEMENT Cutter Deck Belt Removal & InstallationBlade Removal and Sharpening Cutting Blade ServiceStandard Replacement Blades Remove spindle pulley from spindle shaft Electrical Kawasaki Engine onlyElectric Clutch Yellow Black Blue Engine 15A Fuse Year Limited Warranty Disclaimer of WarrantySnapper Product Registration Form Primary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Page Page Page PRO Gear Express MID-SIZE Walk Behind Mowers Series