Section 5 - ADJUSTMENTS & REPAIR
5.8ENGINE ADJUSTMENTS & REPAIR
Refer to the engine owner’s manual for engine adjustments and/or repairs.
5.9MOWER BLADE REPLACEMENT 5.9.1. BLADE WEAR LIMITS
1.Inspect blade frequently for signs of excessive wear or damage. Replace blade when it reaches the wear limit. See Figure 5.14.
5.9.2. BLADE SHARPENING
1.Remove blade. See Figure 5.15.
2.Inspect condition of blade. See Figure 5.14.
3.If blade is in good condition, sharpen at 22 to 28 degrees. DO NOT sharpen beyond original cutting edge. See Figure 5.16.
4.Check blade balance after sharpening. If necessary, correct blade balance by grinding the heavy end of blade.
IMPORTANT: Blade balancing should be performed by a qualified dealer.
5.Reinstall blade. See Figure 5.15. Torque blade mounting bolts to recommended range of 70 to 80 ft. lbs.
NEW BLADE
BLADE
MOUNTING
NUT
SPINDLE
ASSEMBLY
BLADE
SPACERS
BLADE
CONE
WASHER
BLADE
MOUNTING
BOLT
FIGURE 5.15
BLADE
22º TO 28º
WEAR LIMIT (NOTCH STARTS)
ORIGINAL CUTTING EDGE
FIGURE 5.16
DANGEROUS CONDITION!
DO NOT USE ON MOWER!
REPLACE WITH NEW BLADE.
FIGURE 5.14
24