Section 4 - ADJUSTMENTS & REPAIR
WARNING
Before attempting any adjustments or repairs, STOP the engine, remove the key, remove the spark plug wire(s) from the spark plug(s) and secure wire(s) away from plug(s).
4.3.6. ADJUSTING MOWER BLADE
The straightness of the mower blade(s) is essential for smooth, even mowing. Adjust blade straightness as follows. NOTE: Follow Steps 1 thru 4 for all deck
sizes.
1.Make sure fuel cap is on tight. Turn fuel shut off valve (If equipped) to the “CLOSED” position. Start engine and allow it to run until engine runs out of fuel. Close vent on fuel filler cap. See Figure 2.3, Page
2.Remove key from ignition switch.
3.Remove spark plug wire(s) and secure away from spark plug(s).
4.Carefully stand YARD CRUISER on rear bumper.
(Adjusting the 33” Deck Blade)
5.Select a point on the deck and mark for reference.
6.Mark blade tips as “A” and “B”.
7.Rotate blade until blade tip “A” is at deck reference mark.
8.Measure the distance between deck lip and blade tip. NOTE: On 33” decks, the measurement between the blade tip and deck lip should be 3/8”. See Figure 4.5.
9.Repeat step 8 with blade tip “B”.
10.If measurement between blade tips and deck are different and there is more than 1/16” difference between blade tip measurements, adjust blade as follows:
a.Loosen
b.Adjust jack screws “IN” or “OUT” until blade tip measurements are within 1/16” of each other and blade tips are 3/8” away from deck lip. See Figure 4.6.
c.Retighten
BLADE TIP
3/8”
DECK LIP
MARK
BLADE
ENDS
3/8” FROM BLADE TIP TO OUTER DECK LIP
FIGURE 4.5
JACKSCREWS
JAM NUTS
FIGURE 4.6
(Adjusting The 38” Deck Blades) NOTE: Follow Steps 1 thru 4 for all deck sizes.
11.Mark each blade’s tips as “A” and “B”. See Figure 4.7.
12.Rotate both blades until blade cutting edges “A” are at their closest point.
13.Measure the distance between both “A” blade cutting edges and deck. See Figure 4.7.
MARK BLADE
TIPS “A” & “B”
FIGURE 4.7
14.Rotate blade until blade cutting edges “B” are together. See Figure 4.8.
15.If the measurements differ by more than 1/6” between either set of blade tips, one or both blades are bent and must be replaced with new blades.
MEASURE FROM BLADE
TIPS TO DECK
X | X + 1/16” |
FIGURE 4.8
16