Section 3 - MAINTENANCE
3.3.2.MOWER COMPONENTS (Continued) 5. Mower Blade Spindle - Lubrication
a. Lubricate spindle bearings with three shots of general purpose grease from grease gun. See Figure 3.4.
UNDERSIDE VIEW OF 33” DECK
LUBRICATE
SPINDLE BEARINGS
2. Front Caster Wheel Pivot Shaft
The front frame cover will not have to be removed to lubricate the pivot shaft. The access hole is at the rear of the front structure underneath frame cover.
a.The pivot shaft grease fitting can be accessed through a hole at the rear of the front structure. Lubricate pivot shaft with three shots of general purpose grease from grease gun. See Figure 3.6.
FRONT STRUCTURE | ACCESS |
| HOLE |
LUBRICATE
PIVOT
SHAFTS
FRONT COVER REMOVED
FIGURE 3.4
6. Mower Deck Linkage - Lubrication
Lubricate all mower deck linkage pivot points with a light coat of motor oil.
3.3.3.YARD CRUISER - LUBRICATION 1. Front Wheel Bearings
Lubricate front wheel bearings with five shots of general purpose grease from grease gun. See Figure 3.5.
LUBRICATE
FRONT WHEEL
BEARINGS
FIGURE 3.5
FIGURE 3.6
3.Parking Brake Pivot Bushings
a.Make sure fuel cap is on tight. Turn fuel shut off valve (If equipped) to the “CLOSED” position. Start engine and allow it to run until engine runs out of fuel. Close vent on fuel filler cap.
b.Remove key from ignition switch.
c.Remove spark plug wire(s) and secure away from spark plug(s).
d.Carefully stand YARD CRUISER on rear bumper.
e.Lubricate both pivot bushings with three shots general purpose grease from grease gun. See Figure 3.7
YARD CRUISER SHOWN WITH
DECK REMOVED. DECK
REMOVAL NOT NECESSARY
FOR LUBRICATION.
LUBRICATE BOTH PIVOT
BUSHINGS
FIGURE 3.7
12