Snapper 13HP manual General Operating Safety, Checks Before Starting, Starting the Engine

Page 11

Operation

GENERAL OPERATING SAFETY

Before first time operation:

Be sure to read all information in the Safety and Operation sections before attempting to operate this tractor and mower.

Become familiar with all of the controls and how to stop the unit.

Drive in an open area without mowing to become accustomed to the unit.

WARNING

If you do not understand how a specific control functions, or have not yet thoroughly read the FEATURES & CONTROLS section, do so now.

Do NOT attempt to operate the tractor without first becoming familiar with the location and function of ALL controls.

CHECKS BEFORE STARTING

Check that crankcase is filled to full mark on dipstick. See the engine Operator’s Manual for instructions and oil recommendations.

Make sure all nuts, bolts, screws and pins are in place and tight.

Fill the fuel tank with fresh fuel. Refer to engine manual for fuel recommendations.

Make sure fuel shut off valve is in the ON position.

WARNING

Before leaving the operator’s position for any reason, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess grease. Do not stop or park tractor over dry leaves, grass or combustible materials.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

WARNING

Never operate on slopes greater than 17.6 percent (10°) which is a rise of 3-1/2 feet (106 cm) vertically in 20 feet (607 cm) horizontally.

Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes.

Mow up and down the face of slopes, not across, use caution when changing directions and DO NOT START OR STOP ON SLOPE.

STARTING THE ENGINE

Make sure the PTO switch is disengaged and the parking brake is engaged.

Set the engine throttle control to FAST throttle position. Then fully close the choke by pulling the knob OUT fully.

NOTE: A warm engine may not require choking.

Manual Start:

Insert the key into the ignition switch and turn it to RUN.

Grasp recoil handle and pull cord briskly. (You may have to pull several times before engine starts. If engine fails to start within a reasonable number of attempts, discontinue and check engine manual for further instructions.)

NOTE: Be sure recoil cord retracts fully into recoil unit. A slack recoil cord can cause serious personal injury and/or damage to unit.

After the engine starts, gradually open the choke (push knob down fully).

Electric Start:

Insert the key into the ignition switch and turn it to

START.

After the engine starts, gradually open the choke (push knob down fully).

Warm up the engine by running it for at least a minute before engaging the PTO lever/switch or driving the mower.

After warming the engine, ALWAYS operate the unit at FULL THROTTLE when mowing.

In the event of an emergency the engine can be stopped by simply turning the ignition switch to STOP. Use this method only in emergency situations. For normal engine shut down follow the procedure given

in STOPPING THE MOWER.

10

Image 11
Contents 13HP Walk-Behind Mower OPERATOR’S ManualTable of Contents Safety Rules & Information Slope Operation Safety Rules and InformationSafe Handling of Gasoline Safety Rules & InformationService & Maintenance ID Tag Identification NumbersCE Identification TAG Markings Monoxide Poisoning Safety DecalsSafety Decals Decal Cutting Height AdjustmentManual Safety IconsSafety Icons Ground Speed Control Handles / Operator Presence Ignition SwitchControl Functions Features & Controls Starting the Engine General Operating SafetyChecks Before Starting Operation Long Term Storage Longer Than 30 Days StorageStarting After Long Term Storage Temporary Storage 30 Days Or LessTire Pressure Check Tire PressureBefore Every Spring Each Hours 100 250 Fall Use OIL & Filter Change Regular MaintenanceChecking / Adding Fuel Fuel FilterGreaseOil LubricationRemoving the Blade Servicing the Mower BladesMaintenance Records Troubleshooting the Mower Troubleshooting, Adjustments, & ServiceTroubleshooting the Mower Deck Troubleshooting, Adjustment & ServiceTo Adjust the Cutting Height Troubleshooting, Adjustment & ServiceCutting Height Adjustment To Adjust the Cutting RangeTo Level the Mower Deck Deck Leveling AdjustmentTransaxle Drive Belt Belt Removal and ReplacementMower Deck Drive Belt 32 model Manual Start Electric Start Ground Speed Control Lever Location AdjustmentAdjusting the Lever Height Adjusting the Lever PositionBlade Brake Check PTO Clutch AdjustmentRO D U C T S