Snapper 13HP manual Troubleshooting, Adjustments, & Service, Troubleshooting the Mower

Page 19

Troubleshooting, Adjustments, & Service

TROUBLESHOOTING

While normal care and regular maintenance will extend the life of your equipment, prolonged or constant use may eventually require that service be performed to allow it to continue operating properly.

The troubleshooting guide below lists the most common problems, their causes and remedies.

See the information on the following pages for instructions on how to perform most of these minor adjustments and service repairs yourself. If you prefer, all of these procedures can be performed for you by your local authorized dealer.

WARNING

To avoid serious injury, perform maintenance on the tractor or mower only when the engine is stopped and the parking brake engaged.

Always remove the ignition key, disconnect the spark plug wire and fasten it away from the plug before beginning the maintenance, to prevent accidental starting of the engine.

TROUBLESHOOTING THE MOWER

PROBLEM

CAUSE

REMEDY

Engine will not turnover or start.

1.

PTO (electric clutch) switch

1. Place in OFF position.

 

 

in ON position.

 

 

 

2.

Out of fuel.

2. If engine is hot, allow it to cool, then refill

 

 

 

 

the fuel tank.

 

3.

Engine flooded.

3. Move throttle control out of CHOKE position.

 

4.

Wiring loose or broken.

4. Visually check wiring & replace broken or

 

 

 

 

frayed wires. Tighten loose connections.

 

5.

Safety interlock switch

5. Replace as needed. See authorized

 

 

faulty.

 

service dealer.

 

6.

Spark plug(s) faulty, fouled

6. Clean and gap or replace.

 

 

or incorrectly gapped.

 

See engine manual.

 

7.

Water in fuel.

7. Drain fuel & refill with fresh fuel.

 

8.

Gas is old or stale.

8. Drain fuel & replace with fresh fuel.

 

 

 

 

Engine starts hard or runs poorly.

1.

Fuel mixture too rich.

1. Clean air filter. Check choke adjustment

 

 

 

 

(throttle control).

 

2.

Spark plug faulty, fouled, or

2.

Clean and gap or replace.

 

 

incorrectly gapped.

 

(See engine manual.)

 

 

 

 

 

Engine knocks.

1.

Low oil level.

1.

Check/add oil as required.

 

2.

Using wrong grade oil.

2.

See engine manual.

 

 

 

 

 

Excessive oil consumption.

1.

Engine running too hot.

1.

Clean engine fins, blower screen and

 

 

 

 

air cleaner.

 

2.

Using wrong weight oil.

2.

See engine manual.

 

3.

Too much oil in crankcase.

3.

Drain excess oil.

 

 

 

 

 

Engine exhaust is black.

1.

Dirty air filter.

1.

Replace air filter. See engine manual.

 

2.

Engine choke control

2.

Open choke control.

 

 

is in closed position.

 

 

 

 

 

 

 

Engine runs, but mower will

1.

Hydraulic release valve rod

1.

Return release rod to DRIVE position.

not drive.

 

in “open” position.

 

 

 

2.

Belt is broken.

2.

See Drive Belt Replacement.

 

3.

Drive belt slips.

3.

See problem and cause below.

 

4.

Brake is not fully released.

4.

See authorized service dealer

 

 

 

 

 

Brake will not hold.

1.

Brake is incorrectly adjusted.

1.

See authorized service dealer.

Mower drives or handles poorly.

1.

Loose control linkages.

1.

Check and tighten any loose connections.

 

2.

Improper tire inflation.

2.

See Regular Maintenance Section.

 

 

 

 

 

18

Image 19
Contents 13HP Walk-Behind Mower OPERATOR’S ManualTable of Contents Safety Rules & Information Slope Operation Safety Rules and InformationService & Maintenance Safety Rules & InformationSafe Handling of Gasoline CE Identification TAG Markings Identification NumbersID Tag Monoxide Poisoning Safety DecalsSafety Decals Decal Cutting Height AdjustmentSafety Icons Safety IconsManual Control Functions Ignition SwitchGround Speed Control Handles / Operator Presence Features & Controls Checks Before Starting General Operating SafetyStarting the Engine Operation Long Term Storage Longer Than 30 Days StorageStarting After Long Term Storage Temporary Storage 30 Days Or LessBefore Every Spring Each Hours 100 250 Fall Use Check Tire PressureTire Pressure OIL & Filter Change Regular MaintenanceChecking / Adding Fuel Fuel FilterGreaseOil LubricationRemoving the Blade Servicing the Mower BladesMaintenance Records Troubleshooting the Mower Troubleshooting, Adjustments, & ServiceTroubleshooting the Mower Deck Troubleshooting, Adjustment & ServiceTo Adjust the Cutting Height Troubleshooting, Adjustment & ServiceCutting Height Adjustment To Adjust the Cutting RangeTo Level the Mower Deck Deck Leveling AdjustmentMower Deck Drive Belt 32 model Belt Removal and ReplacementTransaxle Drive Belt Manual Start Electric Start Ground Speed Control Lever Location AdjustmentAdjusting the Lever Height Adjusting the Lever PositionBlade Brake Check PTO Clutch AdjustmentRO D U C T S