La Crosse Technology WS-9013U instruction manual Indoor Weather Station

Page 6

DETAILED SET-UP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE SENSOR

1.Remove the mounting bracket. The bracket snaps on and off easily.

2.Remove the battery cover, by sliding the cover down.

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

B. INDOOR WEATHER STATION

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower- central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 2 AA batteries.

3.Replace the battery cover.

Battery Cover

Note: Immediately after the batteries

have been installed, each LCD (Liquid Crystal Display) will flash. Within a few seconds the indoor temperature will be displayed. If not, then remove the batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes, remove batteries from both units, wait 10 seconds, and reinstall. The time will show -:-- and start searching for the WWVB signal. If it successfully receives the time signal (usually at night), it will display the correct time (default is Eastern).

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents WS-9013U Wireless 433 MHz Radio-controlled Weather Station Contents Inventory of Contents About Wwvb Radio Controlled Time Quick SET-UP Guide Do not Press ANY Buttons for 15 MinutesIndoor Weather Station Program Mode Programming SequenceII. Function Keys II or 24 Hour Time SettingIII. Time Zone Setting Date LCDIV. Daylight Saving Time DST Setting Wwvb Remote Control Time Manual Time SettingTime VI. Setting the DAY, DATE, and Year VII. Selecting F or C VIII. Setting the LCD Contrast Features of the WS-9013U Indoor TemperatureII. Outdoor Temperature III. Minimum and Maximum Temperature Records Viewing the Indoor Temperature RecordsViewing the Outdoor Temperature Records Resetting the Mimimum and Maximum Records IV. Adding Outdoor Remote Control Senders OptionalSET-UP of Multiple Units Outdoor LCD Mounting Remote Temperature Sensor Mounting with ScrewsMounting with Adhesive Tape II. the Indoor Temperature Station Using the Table StandWall Mounting Troubleshooting Maintenance and Care InstructionsPower Supply SpecificationsTemperature measuring range Dimensions H x W x DWarranty Information FCC ID OMO-01RX receiver, OMO-01TX sensor
Top Page Image Contents