5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT Mount the sensor at least 5 feet (1.5 meters) off the ground (higher is better for wind measurement) in an open area. Secure to fence post, 2”x 4” wood, 3/4” pole, etc. (not included)
LEVEL INSTALLATION Use the bubble level (included on top of sensor) to ensure level installation for accurate wind measurement.
SOLAR CELL INSTALLATION Install the sensor with the solar cell facing SOUTH. This ensures the cell receives as much sun as possible and orients wind direction.
5-in-1 Sensor Installation
1.Fasten mounting base
(included) to a post or pole
(not included) using the 4 longer screws included in the hardware bag.
2.Insert the mounting base into the hole on the bottom of the
sensor.
3. Make sure the arrows on the |
|
|
top of the sensor are pointed |
|
|
in the proper direction and |
|
|
the bubble level is centered. | (1.5 meters) | |
The solar cell should be facing |
|
|
south to properly orient the |
|
|
wind direction. |
|
|
4. Fasten the sensor into the mounting base using the 2 shorter screws included in the hardware bag.
The 5-in-1 sensor is now
ready to use.
Clear Data Collected During Installation
When installation is complete, clear erroneous data from the display unit by pressing the “CLEAR TODAY” button, on the back of the display inside the battery compartment. This button will clear data recorded since 12:00 am.
Basic Setup is Complete
The
12