Troubleshooting
Problem | Possible Solution | |
| • Make sure both the display unit and sensor are | |
| placed away from heat sources or vents (see p.11). | |
Inaccurate | • Make sure both units are positioned away from | |
moisture sources (see p.11). | ||
temperature or | ||
• Make sure sensor is mounted at least 5 ft off the | ||
humidity | ||
ground. | ||
| ||
| • Calibrate indoor and outdoor temperature and | |
| humidity (see p.18). | |
|
| |
| • Verify the rain gauge stabilizer (plastic tab) has been | |
| removed from the bottom of the sensor (see p.7). | |
| • Clear debris, such as leaves, out of the rain collector | |
| funnel and debris screen. | |
No rainfall | • Calibrate the Rain Gauge (see p.19). | |
• Verify the sensor’s internal tipping lever is moving | ||
| ||
| freely by dripping a little water through the rain | |
| collector. You should hear the lever tipping. If you do | |
| not hear it, you may need to clean inside the sensor. | |
| Video available at www.acurite.com/5in1 | |
|
| |
| • What is wind reading being compared to? Pro | |
| weather stations are typically mounted at 30 ft high | |
| or more. Make sure to compare data using a sensor | |
Inaccurate wind | positioned at the same mounting height. | |
• Check location of the sensor. Ensure it’s mounted a | ||
readings | minimum of 5 ft in the air with no obstructions around | |
| it (within several feet). | |
| •Ensure wind cups are spinning freely. If they hesitate | |
| or stop try lubricating with graphite powder or spray | |
| lubricant. | |
|
| |
| • Check that the batteries are installed correctly. | |
Display screen | Batteries may need to be replaced. | |
• Reset the display by pressing the reset button, located | ||
not working | ||
on the back of the display unit. Date and time will | ||
| ||
| need to be entered after a reset. | |
|
|
If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877)
17