Cub Cadet CS 2210, CS3210 warranty Do not modify engine, Spark Arrestor

Page 5

3.Before cleaning, repairing, or inspecting, stop the engine and make certain the impeller and all moving parts have stopped. Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.

4.Do not change the engine governor settings or overspeed the engine. The governor controls the maximum safe operating speed of the engine.

5.Maintain or replace safety and instruction labels, as necessary.

6.Follow this manual for safe loading, unloading, transporting, and storage of this machine.

7.Never store the machine or fuel container inside where there is an open flame, spark or pilot light such as a water heater, furnace, clothes dryer, etc.

8.Allow machine to cool at least 5 minutes before storing.

9.Always refer to the operator’s manual for proper instructions on off-season storage.

10.If the fuel tank has to be drained, do this outdoors.

11.Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.

12.According to the Consumer Products Safety Commission (CPSC) and the U.S. Environmental Protection Agency (EPA), this product has an Average Useful Life of seven (7) years, or 60 hours of operation. At the end of the Average Useful Life have the machine inspected annually by an authorized service dealer to ensure that all mechanical and safety systems are working properly and not worn excessively. Failure to do so can result in accidents, injuries or death.

Do not modify engine

To avoid serious injury or death, do not modify engine in any way. Tampering with the governor setting can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper with factory setting of engine governor.

Notice Regarding Emissions

Engines which are certified to comply with California and federal EPA emission regulations for SORE (Small Off Road Equipment) are certified to operate on regular unleaded gasoline, and

may include the following emission control systems: Engine Modification (EM), Oxidizing Catalyst (OC), Secondary Air Injection (SAI) and Three Way Catalyst (TWC) if so equipped.

Spark Arrestor

Warning: This machine is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered,

brushcovered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).

If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.

A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.

Section 2 — Important Safe Operation Practices

5

Image 5
Contents Operator’s Manual To The Owner Table of Contents Thank You Record Product InformationPreparation Important Safe Operation PracticesCalifornia Proposition Training Safe Handling of Gasoline Maintenance & StorageOperation Spark Arrestor Do not modify engineSymbol Safety SymbolsAssembly Assembly & Set-UpContents of Carton Gas and Oil Fill-Up Set-UpTow Bar Controls and Features Operation Basic Starting ProcedureStarting Engine Stopping EngineClearing the Hopper ShreddingChipping Emptying the BagMaintenance Maintenance & AdjustmentsCleaning The Reduction Chamber Blade Care ServiceChipper Blades Shredder BladeOff-Season Storage Problem Cause Remedy TroubleshootingPage Page Page Component Part Number and Description Replacement PartsShredder Blade Chipper BladeCUB Cadet LLC MANUFACTURER’S Limited Warranty for Manual del operador Gracias Al propietarioRegistro de información de producto Asistencia al ClienteProposición 65 de California Medidas importantes de seguridadCapacitación PreparativosUtilice sólo recipientes para gasolina autorizados Manejo seguro de la gasolinaOperación No modifique el motor Mantenimiento y almacenamientoAviso referido a emisiones GuardachispasSímbolo Símbolos De SeguridadContenido de la caja Montaje y ConfiguraciónMontaje BolsaBarra de Remolque ConfiguraciònLlenado de gasolina y aceite Inserte la lengua en la baseControles Y Características Detención del motor FuncionamientoEncendido del Motor Limpieza de la tolva TrituraciónCorte Vaciado de la bolsaRecomendaciones Generales MantenimientoLubricación Care de EquipoLimpie la cámara de reducción Limpieza del canal de reducciónCuidado de la Cuchilla ServicioLas cuchillas de la cortadora La cuchilla de la trituradoraAlmacenamiento Fuera de Temporada Problema Causa Remedio Solución de problemasEl cable de la bujía. Limpie la pantalla de La unidad no descarga El área de descarga está tapadaDesgranado y el interior de la abertura de DescargaComponente Número de pieza y Descripción Piezas de ReemplazoGarantía Limitada DE CUB Cadet LLC